GQ-100TH
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Applicable telephone line:Public switched telephone networkEffective scanning width:210 mm
Compatibility:ITU-T (CCITT) G3 modeAutomatic document feeder:20 sheets max.
Configuration:Half-duplex, desktop transceiverHalftone (gray scale): 64 levels
Compression scheme:Modified Huffman and Sharp specialContrast control:Automatic/Dark selectable
modeCopy function:Standard
Scanning method:Flat-bed, solid-state CCDTelephone function:Standard
Resolution:Horizontal:(cannot be used if power fails)
8 dot/mmNoise emission:Less than 70 dBA
Vertical:(Measured according to DIN 45635.)
Standar-d3.85 lines/mm
Fine/Halft-o7.ne7 lines/mmPower requirements:220-240 V AC, 50/60 Hz
Super fi-15ne.4 lines/mmOperating temperature: 5 to 35°C
Recording system:Thermal recordingPower consumption:Stand-by: 8 W
Display:7 x 5 dots, 1 line by 16-digit displayMaximum: 120 W
Reception modes:Auto/ManualDimensions:Width: 341 mm
Modem speed:9600 bps with automatic fallback toDepth: 253 mm
7200, 4800, or 2400 bps
Height: 123 mm
Transmission time* :Approx. 15 seconds
(Sharp special mode)Weight:Approx. 2.8kg
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in
Effective recording width:210 mm, max.
Sharp special mode, excluding time for protocol signals (i.e.,
Input document size:Automatic feeding:ITU-T phase C time only).
Width 3 216 mm
Length3 128 to 297 mm
Manual feeding:
Width 3 216 mm
Length3 128 to 1000 mm
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.
1 � 1 |
ACEC
SHARP
