23
AnimationTime-Lapse
Give stationary scenes or objects an illusion ofYou can record sequentially at preset time spans.
movement. This function allows you to shoot aLeaving the camcorder aimed at a specific subject,
series of pictures, each slightly different, of the sameyou can record subtle changes over an extended
object for a brief period of time.period of time.
NOTE:NOTE:
You need the optional RM-V20U remote controlYou need the optional RM-V20U remote control
unit to perform the following procedure.unit to perform the following procedure.
ENGAGE RECORD�STANDBYENGAGE RECORD�STANDBY
MODEMODE
Make sure the lens cover is open, then set theMake sure the lens cover is open, then set the
1power switch to CAMERA.1power switch to CAMERA.
SET RECORDING SPEEDSET RECORDING SPEED
Set SP/LP to SP (Z pg. 7).Set SP/LP to SP (Z pg. 7).
22
SET RECORDING TIMESET RECORDING TIME
Press REC TIME on the remote control. ThreePress REC TIME on the remote control. There
3choices are available, and they appear in the3are three choices available, and they appear in
following order (each time REC TIME isthe following order (each time REC TIME is
pressed): 1/4S (one-fourth of a second), 1/2Spressed): 1/4S, 1/2S and 1S. Press again to
(one-half of a second) and 1S (one full second).reset.
Press again to release the Animation mode.
SET INTERVAL BETWEEN
START RECORDING
RECORDINGS
Press Recording Start/Stop after focusing on the
4subject. The recording stops automatically afterPress INTERVAL on the remote control. There
4are four choices available, and they appear in
the selected period of time.the following order (each time INTERVAL is
pressed): 15S, 30S, 1MIN, and 5MIN. Press
ASSEMBLE SERIES OFagain to reset.
PICTURES
Repeat steps 3 and 4 for the desired number ofSTART TIME-LAPSE
5pictures.RECORDING
CHECK YOUR WORKPress Recording Start/Stop. Recording and
5intervals alternate automatically.
Play back the series of pictures to see if the
6results were satisfactory.RELEASE TIME-LAPSE MODE
To release when the tally lamp is not blinking,
RELEASE ANIMATION MODE
6press INTERVAL and REC TIME repeatedly
Press REC TIME until O� disappears from theuntil O � and O � disappear. To release
7viewfinder.when the tally lamp is blinking, press
Recording Start/Stop to stop the blinking, then
press INTERVAL and REC TIME repeatedly
NOTES:
until O � and O � disappear.
cFor best results, make sure the camcorder is
secured when shooting.NOTES:
cIf the PROGRAM AE dial is set to Self-TimercFade-in/out cannot be performed during
mode, Animation is cancelled and Self-TimerTime-Lapse shooting.
mode is engaged with 15S selected.cFor best results, keep the camcorder secured
cFade-in/out cannot be performed duringwhile shooting.
Animation shooting.cIf, during steps 3 and 4, the PROGRAM AE dial is
set to the Self-Timer mode, the Self-Timer mode is
engaged with 15S selected. |
ACEC
JVC
