CAUTIONS
43
DANGER:General Battery Precautions
Video LightYWhen the RM-V20U (remote control), C-P6U or
Y The video light becomes extremely hot. Do not touch itC-P7U (cassette adapter) are not functioning even
either while in operation or soon after turning it off,when correctly operated, the batteries are
otherwise serious injury may result.exhausted. Replace them with fresh ones.
Y Do not place the camcorder into the carrying case
YUse only the following batteries:
immediately after using the video light, since it remains
RM-V20U ................................. AAA (R03) size
extremely hot.
C-P6U or C-P7U ....................... AA (R6) size
Y When operating, keep a distance of about 30 cm
(1 ft.) between the video light and people or object.
Please make note of the following rules for battery
Y Do not us e near flammable or explosive materials.
use. When misused, batteries can leak or explode.
Serious malfunctioning1. Refer to the RM-V20U and C-P6U/C-P7U
instructions when replacing batteries.
If malfunctioning occurs, stop using the unit2. Do not use old and new batteries together.
immediately and consult your local JVC dealer.
3. Do not use two different kinds of batteries.
Although sizes may be the same, voltages may
When using the AC Power Adapter/Charger in
differ.
areas other than the USA
4. Do not expose batteries to excessive heat as they
n The provided AC Power Adapter/Charger features
can leak or explode.
automatic voltage selection in the AC range from 110 V
5. Do not dispose of batteries in a fire.
to 240 V.
6. Remove batteries from the unit if it is to be stored
USING HOUSEHOLD AC PLUG ADAPTERfor an extended period to avoid battery leakage
In case of connecting the unit's power cord to an AC wall
which can cause malfunctions.
outlet other than American National Standard C73 series
type use an AC plug adapter, called a "Siemens Plug", as
shown.
For this AC plug adapter, consult your nearest JVC dealer.Battery Packs
Plug adapterThe supplied battery pack is a
nickel-cadmium battery. Before
using the supplied battery pack or
an optional battery pack, be sure to
read the following cautions:
INFORMATION
This device complies with Part 15 of FCC Rules. Operation1. To avoid hazard . . .
is subject to the following two conditions:
......do not burn.Terminals
(1) This device may not cause harmful interference, and (2)
......do not short-circuit the terminals.
this device must accept any interference received,
......do not modify or disassemble.
including interference that may cause undesired operation.
......use only specified chargers.
Change or modifications not approved by the party
responsible for compliance could void the user's authority2. To prevent damage and prolong service
to operate the equipment. This equipment has been testedlife . . .
and found to comply with the limits for a Class B digital......do not subject to unnecessary shock.
device, pursuant to Part 15 of the FCC Rules. These limits
......avoid repeated charging without fully discharging.
are designed to provide reasonable protection against
......charge in an environment where
harmful interference in a residential installation. This
temperatures are within the tolerances shown in the
equipment generates, uses, and can radiate radio frequency
chart below. This is a chemical reaction type
energy and, if not installed and used in accordance with
batteryNcooler temperatures impede chemical
the instructions, may cause harmful interference to radio
reaction, while warmer temperatures can prevent
communications. However, there is no guarantee that
complete charging.
interference will not occur in a particular installation.
......store in a cool, dry place. Extended exposure to
If this equipment does cause harmful interference to radiohigh temperatures will increase natural
or television reception, which can be determined by
discharge and shorten service life.
turning the equipment off and on, the user is encouraged to
......avoid prolonged uncharged storage.
try to correct the interference by one or more of the
......remove from charger or powered unit when not in
following measures:
use, as some machines use current even when
Reorient or relocate the receiving antenna.
switched off.
Increase the separation between the equipment and
receiver.3. To prevent damage to the camcorder . . .
Connect the equipment into an outlet on a circuit......replace the battery pack when it begins to deliver
different from that to which the receiver is connected.less recording time per charge.
Consult the dealer or an experienced radio/TV technician
for help. |
ACEC
JVC
