EN 43
FEATURE:Self-Timer, Animation and Time-Lapse
PURPOSE:The remote control lets you set/release
Interval Timer and Rec Time functions
as well as the Menu screen.
OPERATION:Self-TimerTransmitted beam
1) Set
effective area
Instead of performing steps 1 through 3
15!5m(16.4ft)on pg. 32 (OSelf-Timer�), press INT.
TIME on the remote control. Each time
30INT. TIME is pressed, the Interval Timer
!
indicator appears, changing in the
30!Remote sensor
15!following order: 15s, 30s, 1min, 5min
and No indication (off).
When using the remote control, be sure to2) Release
point it at the remote sensor. The aboveInstead of setting OInterval Timer� to
illustration shows the approximate transmittedOOFF� in the Menu, press INT. TIME on
beam effective area for indoor use.the remote control until the Interval
The transmitted beam may not be effective orTimer indicator disappears.
may cause incorrect operation outdoors orAnimation
when the remote sensor is directly exposed to1) Set
sunlight or powerful lighting.Instead of performing steps 1 and 2 on
pg. 33 (OAnimation�), press REC TIME
on the remote control. Each time REC
Index Code Marking
TIME is pressed, the Rec Time indicator
appears, changing in the following
Intervalorder: 1/4s, 1/2s, 1s, 5s and No
Timer Indicatorindication (off).
1minINDEX2) Release
1/2sInstead of using the Menu in step 5 on
pg. 33, press REC TIME on the remote
Rec Time Indicatorcontrol until the Rec Time indicator
disappears.
LCD monitor or
Time-Lapse
viewfinder
1) Set
Instead of performing steps 1 through 3
on pg. 33 (OTime-Lapse�), press INT.
TIME and REC TIME on the remote
control. Each time INT. TIME is
pressed, the Interval Timer indicator
appears, changing in the following
order: 15s, 30s, 1min, 5min and No
indication (off). Each time REC TIME is
pressed, the Rec Time indicator
appears, changing in the following
order: 1/4s, 1/2s, 1s, 5s and No
indication (off).
2) Release
Instead of using the Menu in step 5 on
pg. 33, press INT. TIME and REC TIME
on the remote control until the
indicators disappear.
NOTE:Also refer to pgs. 32 and 33.
START/STOPFEATURE:Index Code Marking
VISSPURPOSE:To give you automatic access to any
selected point on a recording.
OPERATION:1) Press VISS once to place the index
INT. TIME
code. OINDEX� blinks in the LCD
REC TIMEmonitor or the viewfinder during
marking.
NOTE:If VISS is pressed during Record�
Standby mode, the mark is placed
RM-V700U (optional)where START/STOP is pressed. |
ACEC
JVC
