RECORDING Basic Recording
16
NOTE:
LENS COVERYou should already have performed the procedures listed
Switchbelow. If not, do so before continuing.
cPower (Z pg. 8)
cTape Length Setting (Z pg. 12)
cRecording Mode Setting (Z pg. 13)
cGrip Adjustment (Z pg. 14)
LOAD A CASSETTE
First press PUSH/OPEN and open the LCD monitor
1to an angle of over 60 degrees. Press EJECT to open
the cassette holder, then insert
POWERthe cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
Start/Stop
Shooting while watching the LCD monitor
Power indicatorENTER RECORD�STANDBY MODE
Make sure the LCD monitor is fully open. Slide the
2LENS COVER open/close switch to open the lensPUSH/OPEN
cover, then set the power switch to CAMERA.
YThe power indicator lights and the camcorder
enters the Record�Standby mode.
YThe scene youOre aimed at appears in the LCD
monitor, with the word OPAUSE� superimposed
upon it.
START SHOOTING
Tilt the LCD monitor upward/downward for best
3viewability (Z pg. 18) and press the Recording
Start/Stop button.
LCD monitor
YThe tally lamp lights while recording is in progress,
and OREC � appears in the LCD monitor.
YIf you want to turn the tally lamp off, see page 31.
STOP RECORDINGTape remaining time
indicator
Press the Recording Start/Stop button again to stop
120min119min3min
4recording.
1min (Blinking)2min (Blinking)YThe camcorder re-enters the Record-Standby
mode.
0min (Blinking)
NOTES:
* min.....(Now calculating)
cWhen you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(Z pg. 17).
cFor other notes, refer to pg. 17.
Tally lamp |
ACEC
JVC
