Master Page: Right
GR-D200US.book Page 59 Friday, April 11, 2003 1:05 PM
SEPIA: Recorded scenes have a brownish tint To hear the dubbed sound during playback?
like old photos. Combine this with the Cinema Set ?12bit MODE? to ?SOUND 2? or ?MIX?.
mode for a classic look.( pg. 31, 40)
STROBE: Your recording looks like a series of NOTES:
consecutive snapshots.I Sound is not heard from the speaker during Audio
1) To start playback, press PLAY (U).Dubbing.
2) Press EFFECT. The PLAYBACK EFFECT Select I When editing onto a tape that was recorded at
Menu appears.12-bit, the old and new soundtracks are recorded
3) Press EFFECT repeatedly to move the highlight separately.
bar to the desired effect.I If you dub onto a blank space on the tape, the
I The selected function is activated and after sound may be disrupted. Make sure you only edit
2 seconds the menu disappears.recorded areas.
I To deactivate the selected effect, press EFFECT I If feedback or howling occurs during TV playback,
ON/OFF. To reactivate the selected effect press move the camcorder?s microphone away from the
EFFECT ON/OFF again.TV, or turn down the TV?s volume.
I To change the selected effect, repeat from I If you change from 12-bit to 16-bit in mid-
step 2 above.recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
Audio DubbingI During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
The audio track can be customised only when in 16-bit audio or a blank portion, Audio Dubbing
recorded in the 12-bit and SP modes. ( pg. 34)stops.
I To perform Audio Dubbing while watching on the
television, make connections. ( pg. 22)
I To perform Audio Dubbing with a video unit
connected to the camcorder?s S/AV connector, first
set ?S/AV INPUT? to ?A/V. IN? or ?S. IN? in VIDEO
Menu. ( pg. 31, 40)
The ?AUX? indication appears instead of ?MIC?.
ADVANCED FEATURES
Stereo Microphone
Speaker
PAUSE
PLAY
A.DUB
PLAYA.DUB
STOP
PAUSET
W
STOP
RM-V717U (optional) RM-V718U (provided)
1Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2While holding A. DUB (D) on the remote
control, press PAUSE (9). The ?9D? and ?MIC?
indicators appear.
3Press PLAY (U), then begin ?narrating?. Speak
into the microphone.
I To pause dubbing, press PAUSE (9).
4To end Audio Dubbing, press PAUSE (9), then
STOP (8). |
ACEC
JVC
