MasterPage: Left
GR-D231US.book Page 10 Wednesday, February 4, 2004 4:00 PM
GETTING STARTED10 EN
How To Attach The Lens CapHow To Use The Audio Extension Cable
To protect the lens, attach the When using an optional
provided lens cap to the external microphone,
Open the
camcorder as shown in the connect to the provided
cover.MIC
illustration. Audio extension cable
(with a core filter
NOTE:
attached), then connect To MIC
To confirm the lens cap is on
the Audio extension
correctly make sure the cap is flush
to the camcorder. cable to the camcorder. Core filter
The core filter reduces
interference. (See
Audio extension cable
below.) (provided)
Stereo microphone
Place here during shooting.
How To Attach The Core Filter
Attach the core filters to the cables. The core filter
reduces interference.
How To Attach The Shoulder Strap1Release the stoppers on both ends of the core filter.
Follow the illustration.
1Thread the strap through the eyelet.
2Fold it back and thread it through the strap guide and
Stopper
the buckle.
I To adjust the length of the strap, loosen and then tighten 2Run the cable through the core filter, leaving approx.
the strap in the buckle.3 cm of cable between the cable plug and the core filter.
3Slide the strap guide fully towards the eyelet.
USB cable and AC Adapter?s cord
BuckleWind the cable (cord) once around the outside of the
core filter as shown in the illustration.
Strap guide
2Core filter (large: USB Cable, small:
AC Adapter?s cord)
3 cm (1-3/16")
Wind once.
3
1Audio Extension cable
Wind the cable twice around the outside of the core filter
Eyelet
as shown in the illustration.
3 cm (1-3/16")Core filter (small)
Wind twice.
I Wind the cable so that it is not slack. |