62 ENINDEX Indications (cont.)
Warning Indications
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded.( pg. 11)
CHECK TAPE OS ERASEAppears when the erase protection tab is set to OSAVE� while the Power
PROTECTION TABSwitch is set to O � or O �.( pg. 11)
Appears if dirt is detected on the heads during recording. Use an optional
cleaning cassette.( pg. 64)HEAD CLEANING
REQUIRED USE
CLEANING CASSETTE
Appears if condensation occurs. When this indication is displayed, wait
more than 1 hour until condensation disappears.
CONDENSATION
OPERATION PAUSED
PLEASE WAIT
Appears if a tape is not loaded when the Recording Start/Stop Button orTAPE!
SNAPSHOT Button is pressed while the Power Switch is set to O � or O �.
TAPE ENDAppears when the tape ends during recording or playback.( pg. 51)
DIFFERENTAppears if a tape in another format is loaded.
FORMATTED TAPE
IAppears when the date/time is not set.( pg. 10)
SET DATE/TIME!IAppears when the built-in clock battery runs out and the previously set
date/time is erased. Consult your nearest JVC dealer for replacement.
LENS CAPAppears for 5 seconds after power is turned on if the lens cap is attached.
Appears if Audio Dubbing is attempted on a blank portion of a tape.
( pg. 47)A. DUB ERROR!
A. DUB ERROR!IAppears if Audio Dubbing is attempted on a tape recorded in the LP
<CANNOT DUBmode.( pg. 47)
ON A LP RECORDEDIAppears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio.( pg. 47)TAPE>
IAppears if A. DUB (e) on the remote control is pressed when the erase<CANNOT DUB
ON A 16BIT
RECORDING>protection tab is set to OSAVE�.( pg. 47)
<CHECK TAPE OS ERASE
PROTECTION TAB>
The error indications (E01 N E06) show what type of malfunction has
E01 N E06
UNIT IN SAFEGUARDoccured. When an error indication appears, the camcorder turns off
MODE REMOVE ANDautomatically. Remove the power supply (battery, etc.) and wait a few
REATTACH BATTERYminutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer. |