EN59
Remote sensor
FEATURE:Slow-Motion Playback
(GR-DVL817 only)
PURPOSE:
To allow slow-speed search in either direction during
video playback.
OPERATION:
1) To change from normal to Slow-Motion Playback, press
SLOW (9 or 0) more than approx. 2 seconds. After
approx. 1 minute in Slow Rewind or approx. 2 minutes
in Slow Forward, normal playback resumes.
To stop Slow-Motion Playback, press PLAY (4).
NOTES:
IYou can also engage Slow-Motion Playback from Still
Playback by pressing SLOW more than approx. 2 seconds.
IDuring Slow-Motion Playback, due to digital image
processing, the picture may take on a mosaic effect.
SLOW IAfter SLOW (9 or 0) is pressed and held, the still image
Forward Buttonmay be displayed for a few seconds, followed by a blue
SLOWscreen for a few seconds. This is not a malfunction.
Rewind ButtonIThere may be a small margin between the slow-motion
PLAYplayback start point you chose and the actual start point for
EFFECTSlow-Motion Playback.
PAUSEIDuring Slow-Motion Playback, there will be disturbances in
ON/OFF
video and the picture may seem unstable, especially with
EFFECTsteady images. This is not a malfunction.
IDuring Slow-Motion Playback, press PAUSE (6) to pause
playback.RM-V716U (Provided with
GR-DVL817 only)
FEATURE:Frame-By-Frame Playback
(GR-DVL817 only)
PLAYBACKEFFECT
PLAYBACK EFFECT
PURPOSE:
Select Menu
To allow frame-by-frame search during video playback.
OFF
1CLASSICFILMOPERATION:
2MONOTONE
3SEPIA1) To change from normal to Frame-By-Frame Playback,
4STROBEpress SLOW (0) repeatedly for forward or SLOW (9)
5VIDEOECHO
repeatedly for reverse. Each time it is pressed, the frame
is played back.
NOTE:
You can also engage Frame-By-Frame Playback from Still
Playback by pressing SLOW (9 or 0) repeatedly.
FEATURE: Playback Special Effects (GR-DVL817 only)
PURPOSE:
To allow you to add creative effects to the playback image.
OPERATION:
1) To start playback, press PLAY (4).
2) Point the remote control at the camcorder's remote sensor and press EFFECT. The PLAYBACK EFFECT Select
Menu appears.
3) Move the highlight bar to the desired effect by pressing EFFECT. The selected function is activated and after
2 seconds the menu disappears.
To deactivate the selected effect, press EFFECT ON/OFF on the remote control. Pressing it again re-activates the
selected effect.
To change the selected effect, repeat from step 2 above.
NOTES:
IWhen some Playback Special Effects are used, the Multi-Analyzer 4 and Multi-Analyzer 9 Snapshot modes
( pg. 42) are not available.
IThe effects that can be used during playback are Classic Film, Monotone, Sepia, Strobe and Video Echo. The effects
work the same in playback as they did in recording. Refer to page 39 for more information. |