EN85
SYMPTOMPOSSIBLE CAUSESCORRECTIVE ACTION
45.The LCD monitor, the45.45.YWipe them gently with soft
viewfinder and the lens NNNNcloth. Wiping strongly can
have become dirty (ex.cause damage ( pg. 92).
fingerprints).
46.An unusual mark appears.46.46.YCheck the section of the
NNNNmanual that explains LCD
monitor/viewfinder
indications ( pg. 88 � 91).
47.An error indication47.YA malfunction of some kind47.YRemove the power supply
(E01 N E06) appears.has occurred. In this case(battery pack, etc.) and wait a
the camcorderOs functionsfew minutes for the indication
become unusable.to clear. When it does, you
can resume using the
camcorder.
If the indication remains even
though you repeat the above
two or three times, please
consult your nearest JVC
dealer.
48.The charger indicator on48.YThe temperature of the48.YTo protect the battery, it is
the AC Power Adapter/battery is extremely high/low.recommended to charge it
Charger does not light.YCharging is difficult inin places with a temperature
places subject to extremelyof 10!C to 35!C ( pg. 93).
high/low temperatures.
49.Picture does not appear on49.YThe viewfinder is pulled49.YPush the viewfinder back in.
the LCD monitor.out.YAdjust the brightness of the
YThe LCD monitor'sLCD monitor ( pg. 16).
brightness setting is tooYIf the monitor is tilted
dark.upward 180 degrees, open
the monitor fully ( pg. 16).
50.When the image is printed50.YThis is not a malfunction.50.YBy recording with ODIS�
from the printer, a blackactivated ( pg. 32) this
bar appears at the bottomcan be avoided.
of the screen.
51.When the camcorder is51.YThe DV cable was plugged/51.YTurn the camcorderOs power
connected via the DVunplugged with poweroff and on again, then
connector, the camcorderturned on.operate it.
does not operate.
52.During transport, the lens52.52.YDo not subject the
cover opens.camcorder to shock or
excessive vibration during
NNNN
transport.
YTurn the camcorder on and
off. The lens cover closes. |
ACEC
JVC
