EDITING (Cont.)
66 EN
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording
with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
Power Dial
RM-V708U or
RM-V710U (provided)
RECORDING
START/STOP
TW
DISPLAY
6wRemote sensorINSERT
PLAY
PAUSE
12:34
REW(IND)
FIND EDIT OUT POINTSTART RECORDING
1Open the LCD monitor and turn the Power4Press RECORDING START/STOP to begin
Dial to "PLAY" while pressing down the lockediting.
button located on the dial. Confirm the time
code at this point (Z pg. 55).YConfirm the insert at the time code you
checked in step 1.
FIND EDIT IN POINT
2Press REW until the point is located, then pressPAUSE DURING EDITING
PAUSE.5Press RECORDING START/STOP. Press again
to resume editing.
PREPARE FOR INSERT EDITING
3Press and hold INSERT on the remote control,STOP EDITING
6Press RECORDING START/STOP, then press
then press PAUSE. O6w� and the Time Code
(min.:sec.) appear in the LCD monitor.STOP.
NOTES:
cWhen performing Insert Editing, the tapeOs Video Area and Sub-Code Area (Z pg. 6) are rewritten, so the date
and time information changes.
cIf you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
cDuring Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting
stops and "ERROR: REFER MANUAL" appears on the LCD monitor. |
ACEC
JVC
