CAUTIONS (cont.)
94 EN
.... in places subject to excessive shock or vibration.
Memory Cards.... near a television set.
To properly use and store your memory cards, be.... near appliances generating strong magnetic or
sure to read the following cautions:electric fields (speakers, broadcasting anten-
nas, etc.).
1. During use . . .
.... in places subject to extremely high (over 40!C)
.... make sure the memory card bears the SD or
or extremely low (under 0!C) temperatures.
MultiMediaCard mark.
.... make sure the memory card is positioned3. DO NOT leave the unit . . .
properly when inserting..... in places of over 50!C.
2. While the memory card is being accessed (during.... in places where humidity is extremely low
recording, playback, deletion, initialisation, etc.) . . .(below 35%) or extremely high (above 80%).
.... never unload the memory card and never turn.... in direct sunlight.
off the camcorder..... in a closed car in summer.
.... near a heater.
3. Store memory cards . . .
.... away from heaters or other heat sources.4. To protect the unit, DO NOT . . .
.... out of direct sunlight..... allow it to become wet.
.... where they wonOt be subject to unnecessary.... drop the unit or strike it against hard objects.
shock or vibration..... subject it to shock or excessive vibration
.... where they wonOt be exposed to strongduring transportation.
magnetic fields (such as those generated by.... keep the lens directed at extremely bright
motors, transformers or magnets).objects for long periods.
.... expose the lens to direct sunlight.
.... carry it by holding the LCD monitor or the
LCD Monitor
viewfinder.
1. To prevent damage to the LCD monitor,.... swing it excessively when using the hand strap
DO NOT . . .or the grip.
.... push it strongly or apply any shocks.
5. Dirty heads can cause the following problems:
.... place the camcorder with the LCD monitor on
the bottom.
2. To prolong service life . . .
.... avoid rubbing it with coarse cloth.
3. Be aware of the following phenomena for LCD
monitor use.
These are not malfunctions:
YWhile using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
YNo picture during playback.
monitor may heat up.
YBlocks of noise appear during playback.
YIf you leave power on for a long time, the
YDuring recording, the Head Clog Warning
surface around the LCD monitor becomes hot.
indicator O � appears.
In such cases, use an optional cleaning cassette.
Main Unit
Insert it and play back. If the cassette is used
1. For safety, DO NOT . . .more than once consecutively, damage to the
.... open the camcorderOs chassis.video heads may result. After the camcorder
.... disassemble or modify the unit.plays back for about 20 seconds, it stops
.... short-circuit the terminals of the battery pack.automatically. Also refer to the cleaning cassetteOs
Keep it away from metallic objects when not ininstructions.
use.If, after using the cleaning cassette, the problems
.... allow inflammables, water or metallic objectsstill exist, consult your nearest JVC dealer.
to enter the unit.Mechanical moving parts used to move the video
.... remove the battery pack or disconnect theheads and video tape tend to become dirty and
power supply while the power is on.worn out over time. In order to maintain a clear
.... leave the battery pack attached when thepicture at all times, periodic check-ups are
camcorder is not in use.recommended after using the unit for about
1,000 hours. For periodic check-ups please
2. Avoid using the unit . . .
.... in places subject to excessive humidity or dust.consult your nearest JVC dealer.
.... in places subject to soot or steam such as near
a cooking stove. |
ACEC
JVC
