Master Page: Right
GR-DVP7-5A_37-79.fm Page 63 Monday, March 18, 2002 1:06 PM
EN 63
1Make sure all units are turned off.
Dubbing To A Video Unit Equipped
2Connect this camcorder to a video unit equipped
with a DV input connector using a DV cable as
With A DV IN Connector
shown in the illustration.
(Digital Dubbing) 3Set this camcorder?s VIDEO/MEMORY Switch to
?VIDEO?.
It is also possible to copy recorded scenes from the
4Set this camcorder?s Power Switch to ?P?
camcorder onto another video unit equipped with a
while pressing down the Lock Button located on
DV connector. Since a digital signal is sent, there is
the switch.
little if any image or sound deterioration.
5Turn on the video unit?s power.
6Insert the source cassette in this camcorder.
7Insert the recording cassette in the video unit.
8Press 4/9 on this camcorder to start playback of
the source cassette.
9At the point you want to start dubbing, engage
the video unit?s Record mode.
10To pause dubbing, engage the video unit?s
Record-Pause mode and press 4/9 on this
camcorder.
Connector
Cover*11Repeat steps8-10 for additional editing. Stop
To DV IN/OUT
the video unit and camcorder.
NOTES:
I It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
DV cable
Core filterbattery pack. ( pg. 11)
(optional)
I If the remote control is used when both the player
and recorder are JVC video units, both units will
perform the same operation. To prevent this from
happening, press the buttons on both units.
To DV IN
I If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
I Even though the DV cable is connected correctly,
sometimes the image may not appear in step 9. If
this occurs, turn off the power and make
connections again.
I If ?Playback Zoom? ( pg. 68) or ?Playback
Special Effects? ( pg. 69) is attempted or
SNAPSHOT is pressed during playback, only the
Video unit equipped with
original playback image recorded on the tape is
DV connector
output from the DV IN/OUT connector.
I When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.
* When connecting the cable, open the cover.
GR-DVP7-5A_37-79.fmPage 63 |
ACEC
JVC
