CAUTIONS (cont.)
108 EN
.... in places subject to extremely high (over 40!CHow To Handle A CD-ROM
or 104!F) or extremely low (under 0!C or 32!F)YTake care not to soil or scratch the mirror surface
temperatures.(opposite to the printed surface). Do not write
3. DO NOT leave the unit . . .anything or put a sticker on either the front or
.... in places of over 50!C (122!F).back surface. If the CD-ROM gets dirty, gently
.... in places where humidity is extremely lowwipe it with a soft cloth outward from the centre
(below 35%) or extremely high (above 80%).hole using a circular motion.
.... in direct sunlight.YDo not use conventional disc cleaners or cleaning
.... in a closed car in summer.spray.
.... near a heater.YDo not bend the CD-ROM or touch its mirror
4. To protect the unit, DO NOT . . .surface.
.... allow it to become wet.YDo not store your CD-ROM in a dusty, hot or
.... drop the unit or strike it against hard objects.humid environment. Keep it away from direct
.... subject it to shock or excessive vibrationsunlight.
during transportation.
.... keep the lens directed at extremely bright
objects for long periods.
.... expose the lens to direct sunlight.About moisture condensation . . .
.... carry it by holding the LCD monitor or the
c You have observed that pouring a cold liquid
viewfinder.into a glass will cause drops of water to form
.... swing it excessively when using the hand strap
on the glass� outer surface. This same
or the grip.phenomenon occurs on the head drum of a
.... swing the soft camera case excessively when
camcorder when it is moved from a cool
the camcorder is inside it.place to a warm place, after heating a cold
5. Dirty heads can cause the following problems:room, under extremely humid conditions or
in a place directly subjected to the cool air
from an air conditioner.
c Moisture on the head drum can cause severe
damage to the video tape, and can lead to
internal damage to the camcorder itself.
Serious malfunctioning
YNo picture during playback.
YBlocks of noise appear during playback.If malfunctioning occurs, stop using the unit
YDuring recording, the Head Clog Warningimmediately and consult your local JVC dealer.
indicator O � appears.
In such cases, use the optional Cleaning Cassette.
Insert it and play back. If the cassette is usedThe camcorder is a microcomputer-controlled
more than once consecutively, damage to thedevice. External noise and interference (from a
video heads may result. After the camcorderTV, a radio, etc.) might prevent it from function-
plays back for about 20 seconds, it stopsing properly. In such cases, first disconnect its
automatically. Also refer to the Cleaningpower supply unit (battery pack, AC Power
CassetteOs instructions.Adapter/Battery Charger, etc.) and wait a few
If, after using the Cleaning Cassette, the problemsminutes and then re-connect it and proceed as
still exist, consult your nearest JVC dealer.usual from the beginning.
Mechanical moving parts used to move the video
heads and video tape tend to become dirty and
worn out over time. In order to maintain a clear
picture at all times, periodic check-ups are
recommended after using the unit for about
1,000 hours. For periodic check-ups please
consult your nearest JVC dealer. |
ACEC
JVC
