EN11
Operation SwitchDate/Time Settings
Date and time will automatically be recorded on tape at
AMall times. It is your choice to display it or not during
playback (Z pg. 55).
SELECT OPERATION MODE
1Set the Operation Switch to O �. Then, set the
Power Switch to O� or O5S� (or O�) while
pressing down the Lock Button. Open the LCD
monitor fully or pull out the viewfinder fully.
YThe power lamp comes on and the camcorder is
turned on.
Lock ButtonACCESS RECORDING MENU
2Press MENU/SET. The Recording Menu appears.
ACCESS MODE MENUPower lamp
OFFCAME3
/PCRAMove the highlight bar to OTO MODE MENU� by
PLAY5SDSrotating MENU/SET. Press it and the Mode Menu
C
D
YALPCSappears.
ACCESS DATE/TIME MENU
4Move the highlight bar to OTO DATE/TIME MENU�
MENU/SET DialPower Switch
by rotating MENU/SET. Press it and the Date/Time
Menu appears.
Display
INPUT DATE AND TIME
5Move the highlight bar to ODATE/TIME� by rotating
P. AEOFFRecording Menu
/ EFFECTMENU/SET. Press it and Oday� is highlighted and
FLASH ADJ.0
4TO MODE MENUbegins blinking.
Rotating MENU/SET, input the day. Press it. Repeat the
END
procedure to input the month, year, hour and minute.
YPress MENU/SET twice when the highlight bar is set
to ORETURN� to exit.
GAIN UPAGCMode Menu
SELF-TIMEROFF
FLASHAUTORegarding Built-in ClockOs Rechargeable Lithium Battery
4TO DATE / TIME MENU
TO SYSTEM MENUTo store the date/time in memory, the clockOs rechargeable
END� � � � �6� � � � �lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC Power
Adapter/Charger, or while the battery pack attached to the
DATE/TIME
Date/Time Menucamcorder continues to supply power to the camcorder, the
INDICATIONONclockOs rechargeable lithium battery is always charged.
ON SCREENOFF
DISPLAYONHowever, if the camcorder is not used for approx. 3 months,
4DATE / TIME1 . 1 . 00
00 : 00the clock lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
RETURN
Power Adapter/Charger for over 24 hours to charge the
clockOs rechargeable lithium battery. Then perform the date/
time setting before using the camcorder.
It is also possible to use the camcorder without the date/
time setting.
NOTE:
Even if you select ODATE/TIME�, if the parameter is not highlighted the camcorderOs internal clock continues to
operate. Once you move the highlight bar to the first date/time parameter (day), the clock stops. When you
finish setting the minute and press MENU/SET, the date and time begin operation from the date and time you
just set. |
ACEC
JVC
