For Your Maintenance
About moisture condensation . . .
I You have observed that pouring a cold liquid into a1) After Use
glass will cause drops of water to form on the glass
outer surface. This same phenomenon occurs on the1. Turn off the camcorder.
head drum of a camcorder when it is moved from a2. Slide and hold OPEN/EJECT u in the direction
cool place to a warm place, after heating a cold room,of the arrow, then pull the cassette holder cover
under extremely humid conditions or in a place directlyopen until it locks. The cassette holder opens
subjected to the cool air from an air conditioner.automatically. Remove the cassette.
I Moisture on the head drum can cause severe
damage to the video tape, and can lead to internal3. Press OPUSH HERE� to close the cassette holder.
damage to the camcorder itself.Y Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
Serious malfunctioning
4. Tilt the viewfinder upward. Press BATT.
If malfunctioning occurs, stop using the unitRELEASE y and remove the battery pack.
immediately and consult your local JVC dealer.
2) Cleaning The Camcorder
1. To clean the exterior, wipe gently with a soft cloth.
Put the cloth in diluted mild soap and wring it well
The camcorder is a microcomputer-controlledto wipe off heavy dirt. Then wipe again with a dry
device. External noise and interference (from a TV,cloth.
a radio, etc.) might prevent it from functioning
properly. In such cases, first disconnect its power2. Open the LCD monitor. Wipe gently with a soft
cloth. Be careful not to damage the monitor.
supply unit (battery pack, AC Adapter, etc.) and wait
a few minutes and then re-connect it and proceedClose the LCD monitor.
as usual from the beginning.3. To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
4. To clean the viewfinder, pull out the viewfinder
and open it.
5. Insert a lens blower or soft cloth and clean the
interior of the viewfinder with it.
6. Close the viewfinder and push it back in.
NOTES:
I Avoid using strong cleaning agents such as benzine or
alcohol.
I Cleaning should be done only after the battery pack has
been removed or other power units have been
disconnected.
I Mould may form if the lens is left dirty.
I When using a cleaner or chemically treated cloth refer to
the cautions of each product.
Lens blower
EN
CAUTIONS39
01 DX55/45/35/25EK_EN 34-483903.1.23, 1:43 PM |
ACEC
JVC
