CAUTIONS (cont.)
50 EN
For Your MaintenanceThis device complies with Part 15 of FCC Rules.
Operation is subject to the following two
1. After Use
conditions:
1Set the Power Switch to OOFF� to turn off the(1) This device may not cause harmful
camcorder.interference, and (2) this device must accept any
2Open the LCD monitor to an angle of over 60interference received, including interference that
degrees. Slide EJECT to open the cassettemay cause undesired operation.
holder, then remove the cassette.Change or modifications not approved by the
3Close and lock the cassette holder by pressingparty responsible for compliance could void the
the Close button.userOs authority to operate the equipment. This
equipment has been tested and found to comply
4Close and lock the LCD monitor.
with the limits for a Class B digital device,
5Slide BATTERY RELEASE to remove the battery
pursuant to Part 15 of the FCC Rules. These
pack.
limits are designed to provide reasonable
6Attach the provided lens cap to the camcorderOs
protection against harmful interference in a
lens.residential installation. This equipment gener-
2. Cleaning The Camcorderates, uses, and can radiate radio frequency
energy and, if not installed and used in accord-
1CLEAN EXTERIOR
ance with the instructions, may cause harmful
Wipe gently with a soft cloth.
interference to radio communications. However,
Put cloth in diluted mild soap and wring it well
there is no guarantee that interference will not
to wipe off heavy dirt, then wipe again with a
occur in a particular installation. If this equip-
dry cloth.
ment does cause harmful interference to radio or
2CLEAN LCD MONITOR
television reception, which can be determined
Open the LCD monitor and wipe it gently with
by turning the equipment off and on, the user is
a soft cloth. Be careful not to damage the
encouraged to try to correct the interference by
monitor. Close the LCD monitor.
one or more of the following measures:
3CLEAN LENSReorient or relocate the receiving antenna.
Blow it with a blower brush, then wipe it gently
Increase the separation between the equip-
with lens cleaning paper.ment and receiver.
4REMOVE EYEPIECEConnect the equipment into an outlet on a
Turn the eyepiece counterclockwise and pull itcircuit different from that to which the receiver
out.is connected.
5CLEAN VIEWFINDERConsult the dealer or an experienced radio/TV
Remove dust using a blower brush.technician for help.
6RE-ATTACH EYEPIECE
Re-attach the eyepiece and turn it clockwise.
NOTES:This Class B digital apparatus complies with
cAvoid using strong cleaning agents such as benzineCanadian ICES-003.
or alcohol.
Cet appareil numŽrique de la classe B est
cCleaning should be done only after the battery
conforme ? la norme NMB-003 du Canada.
pack has been removed or other power units have
been disconnected.
cMold may form if the lens is left dirty.
cWhen using a cleaner or chemically treated cloth,
refer to the cautions that came with it.
cWhen removing the eyepiece, be sure to hold the
viewfinder securely. |
ACEC
JVC
