1.2 JIGS AND TOOLS REQUIRED FOR DISASSEMBLY,1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
ASSEMBLY AND ADJUSTMENTAND BOARD ASSEMBLY
1.2.1 Tools required for adjustments1.3.1 Disassembly flow chart
Torque DriverBitThis flowchart indicates the disassembly step for the cabi-
12
YTU94088YTU94088-003net parts and board assembly in order to gain access to
item(s) to be serviced. When reassembling, perform the
step(s) in reverse order.
1ZOOM OPE UNIT
TweezersChip IC Replacement Jig2FRONT COVER ASSY
34
P-895PTS40844-2
UPPER CASE ASSY
3
(Inc. @ MONITOR ASSY)
4DSC BOARD ASSY
Cleaning Cloth
5
KSMM-01
5REAR COVER ASSY
6VF UNIT
7OP BLOCK ASSY
Table 1-2-1
LOWER CASE ASSY
8
(Inc.JACK,EJECT BOARD ASSY)
1. Torque driver
Be sure to use to fastening the mechanism and exterior
parts because those parts must strictly be controlled forMAIN BOARD ASSY
9
tightening torque.
2. Bit0
PRE/MDA BOARD ASSY,
This bit is slightly longer than those set in conventional/
MECHANISM ASSY
torque drivers.!
3. Tweezers
Table 1-3-1
To be used for removing and installing parts and wires.
4. Chip IC replacement jig
To be used for adjustment of the camera system.
5. Cleaning cloth
Recommended cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens
surface.
1-2 |
ACEC
JVC
