1.2 JIGS AND TOOLS REQUIRED FOR DISASSEMBLY,1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
ASSEMBLY AND ADJUSTMENTAND BOARD ASSEMBLY
1.2.1 Tools required for adjustments1.3.1 Disassembly flow chart
Torque driverBitThis flowchart indicates the disassembly step for the cabi-
12
YTU94088YTU94088-003net parts and board assembly in order to gain access to
item(s) to be serviced. When reassembling, perform the
step(s) in reverse order.
1FRONT COVER ASSY
TweezersChip IC replacement jig
34
P-895PTS40844-2UPPER CASE ASSY
2
( Incl MONITOR ASSY )
/
3
COVER (DV)
/
4
COVER (JACK)
Cleaning cloth
5
KSMM-015MONITOR ASSY
TOP COVER ASSY
6
( Incl MIC UNIT )
LOWER CASE ASSY
7
Table 1-2-1( Incl OP BLOCK ASSY / E.VF ASSY )
1. Torque driver
8OP BLOCK ASSY
Be sure to use to fastening the mechanism and exterior
parts because those parts must strictly be controlled for
tightening torque.
9OP BRACKET
2. Bit
This bit is slightly longer than those set in conventional
torque drivers.0E.VF ASSY
3. Tweezers
To be used for removing and installing parts and wires.!AUDIO BOARD ASSY
4. Chip IC replacement jig
To be used for adjustment of the camera system.@MDA BOARD ASSY
5. Cleaning cloth
Recommended cleaning cloth to wipe down the videoMAIN BOARD ASSY
#
heads, mechanism (tape transport system), optical lens
surface.
$MECHANISM ASSY
Table 1-3-1
1-2 |
ACEC
JVC
