1.2 JIGS AND TOOLS REQUIRED FOR DISASSEMBLY,1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
ASSEMBLY AND ADJUSTMENTAND BOARD ASSEMBLY
1.2.1 Tools required for adjustments1.3.1 Disassembly flow chart
Torque DriverBitThis flowchart indicates the disassembly step for the cabi-
12
YTU94088YTU94088-003net parts and board assembly in order to gain access to
item(s) to be serviced. When reassembling, perform the
step(s) in reverse order.
1COVER (UNDER)
TweezersChip IC Replacement Jig
342COVER (SHOE)
P-895PTS40844-2
3MIC COVER ASSY
UPPER CASE ASSY
4
(Inc.MONITOR ASSY)
Cleaning Cloth
5
KSMM-01
5MONITOR ASSY
6SHUTTER ASSY
LOWER CASE ASSY
Table 1-2-1
(Inc.MICROPHONE
7 /E.VF UNIT
1. Torque driver
/AUDIO BOARD ASSY
Be sure to use to fastening the mechanism and exterior
/OP BLOCK ASSY)
parts because those parts must strictly be controlled for
tightening torque.
8MAIN BOARD ASSY
2. Bit
This bit is slightly longer than those set in conventional
torque drivers.
9MECHANISM ASSY
3. Tweezers
To be used for removing and installing parts and wires.
0MICROPHONE
4. Chip IC replacement jig
To be used for adjustment of the camera system.
E. VF UNIT
!
5. Cleaning cloth
Recommended cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens@AUDIO BOARD ASSY
surface.
#OP BLOCK ASSY
$SHOE ASSY
Table 1-3-1
1-2 |
ACEC
JVC
