1.9 HOW TO TAKE OUT CASSETTE TAPE MANUALLY
1.9.1 How to remove cassette tape manually from the set
If the cassette tape is not ejected from the cassette housing5. Turn the center gear assembly with a sharp-pointed thing
because of some electric trouble, it can be removed from(chip IC replacing jig, etc.) in the direction of the arrow to
the set by the temporary measure that is to turn the loadingwind up the tape. Carefully turn the center gear assem-
motor forcibly as mentioned below.bly not to damage the tape.
Through the removing work, pay heed to the exterior partsIf the tape cannot be wound up by turning the center
such as the covers, etc. as well as to the cassette tape to getgear assembly, it is thinkable that the idler arm assembly
nothing damaged.is positioned not to engage with the reel disk assembly. If
so, shift the mechanism mode so that the idler arm as-
<Procedure>sembly is correctly engaged with the reel disk assembly.
After fine adjusting the engagement, try to wond up the
1. Disconnect the power supply (battery or DC cord) from
tape is the same manner once more.
the set.
In such the event, it is recommended to shift the idler
2. Disconnect the cover (ADJ) from the lower case.arm assembly slightly in the loading direction.
3. Open the front cover.6. After confirming that the tape is completely wound up,
proceed with unloading operation until the mechanism
4. Supply 3 V DC to the terminals (electrodes) on the top of
enters the eject mode. Then, take the cassette tape out
the loading motor to slide the slide deck assembly to the
of the cassette housing.
front side, and stop the power supply when both the pole
bases are positioned in the unloading status inside the7. After removing the cassette tape, check to see if the manu-
tape. Since the tape remains as it is not wound up at thatally wound part of the tape is not soiled with grease, etc.
time, pay careful attention to the tape not to damage itAt the same time, check the mechanism assembly, par-
and not to soil it with grease, etc.ticularly the tape transport system, whether there is some-
If unloading operation is continued after both the polething abnormal or not.
bases return to their respective positions inside the tape,
the mechanism enters the eject mode and the cassette
housing assembly is lifted up. If it occures, the pulled out
tape may be caught in the cassette lid and the tape may
be resultingly damaged.
COVER(M. ADJ)
DC3V
LOADING
MOTOR
CAPSTAN
MOTOR
DRUM
2
3
4
REEL DISK1REEL DISK
(SUP)(TU)
Fig. 1-9-1
1-11
ACEC
JVC
