TROUBLESHOOTING
Before consulting your JVC dealer, please check the following to see if you can correct the problem yourself.
Vertical white lines appear when shooting a veryPlayback picture is blurred or interrupted.
bright object.YThe video heads are dirty or worn out. Consult your
YThis sometimes occurs when the contrast between thenearest JVC dealer for head cleaning or replacement.
back-ground and the object is great. It is not a defect ofThe tape stops during fast-forward or rewind.
the camcorder.YThe Counter Memory Function has been activated
Bright, crystal-shaped spots appear in the LCD( pg. 14, OCounter Memory�).
monitor and the viewfinder.The date and time displays disappear.
YSunlight is directly entering the lens. This is not a defect
of the camcorder.YIf you remove the power source from the camcorder
while the power is on, all settings and selections are
Colored bright spots appear all over the LCD monitorerased. Make sure to turn the camcorderOs power off
or the viewfinder.before disconnecting the power source.
YThe LCD monitor and the viewfinder are made with high-The tape will not eject.
precision technology. However, black spots or brightYThe battery pack is running low.
spots of light (red, green or blue) may appear constantlyYIf the LCD monitor is not open over 60 degrees, the
on the LCD monitor or in the viewfinder. These spots areEJECT switch t does not function.
not recorded on the tape. This is not due to any defect of
the unit. (Effective dots: more than 99.99 %.)
The camcorder is a microcomputer-controlled device.
Animation or Time-Lapse is not available.External noise and interference (from a TV, a radio,
YBefore recording in the Animation mode at the veryetc.) might prevent it from functioning properly. In such
beginning of a tape, set the camcorder to the Recordingcases, first disconnect its power supply unit (battery
mode for about 5 seconds, so that the tape runs
smoothly. Using the Fade-in function at this point is apack, AC Adapter, etc.); and then re-connect it and
good way to begin an animated programproceed as usual from the beginning.
( pg. 21, REC TIME/INT. TIME in SYSTEM MENU).
The tape is running, but there is no playback picture.
YThe TV has not been set to its VIDEO mode or channel.
YIf A/V connection is used, the Os VIDEO/TV STVwitch
has not been set to VIDEO.
24
GR-SXM740U_EN2424/03/1905, 9:22 PM |
ACEC
JVC
