Installing & Setting Up the Driver (Windows)
 Windows Me users
1.With the GS-10 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2.Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar software, be sure to exit it Turn on power to your various
as well.devices in the order specified.
By turning on devices in the
3.Before connecting the USB cable, switch the GS-10Os driver mode to OStandard.�wrong order, you risk causing
For instructions on switching the GS-10Os driver modes, refer to OSwitching the Driver Mode� (p. 80).malfunction and/or damage to
other devices.
4.With the power switch turned OFF, use the USB cable to connect the GS-10 to
your computer.
5.Make sure that the GS-10Os OUTPUT LEVEL is set to the lowest setting, then This unit is equipped with a
protection circuit. A brief
switch ON the POWER switch.
Windows will detect the GS-10, and the OAdd New Hardware Wizard� dialog box will appear.interval (a few seconds) after
fig.11-260power up is required before
the unit will operate normally.
6.Make sure that Automatic search for a better driver (Recommended) is selected,
and click [Next].
Driver detection will begin.
When the driver has been found, driver installation will begin.
Once the driver has been installed, a dialog box will inform you of this.
fig.11-270
7.Click [Finish].
8.Restart Windows.
? Next, you need to make the driver settings (p. 141).
137 |
ACEC
BOSS
