How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, c6.losOne thece th e Start indicator lamp has To lower: pull out two sithede Lower rack
door properly and open the water switched off press the On/Off butthaonndl to es and gently lower the rack.
supply tap.switch the dishwasher o All theff. To raise: pull up thetwo side h andles
A
2. Press the On/Off button to switchindic the ator lamps switch off.until the rack clicks into place.
dishwasher oOnn.e o f the programme 7. Open the door (warning: beware of ho Thet rack must be level on both
indicator lamps will switch on.steam). Unload the lower rack befosidre es.A
the upper one. Close the water Crtapoc.kery holders:
3. Select the desired programme by
Upper rack Down: cups and long-stemmed glasses.
pressing the corresponding button. Up: plates.
The corresponding indicator lamp
lights uIfp. required, select options
(if supplied).C
4. Press the Start button to start the
selected programmThee. Start
indicator lamp will light up Once s.et,
the programmed data cannot be
altered by pressing the programme ?Vario Organizer? multi-purpose Plate holders:
selector buttons.support:
To be used, for example, May be lowered to increase
Note: once the Start button has been
for long-handled ut(arrange ensils available spacA).e (
pressed, the dishwasher memorises the knives with the blade facing
last programme selected. This A
downwards), cups and glasses.
information remains in the memory even
during interruption of the power supply. May be used in three different
positions (see ?Dishwasher also
To change the selected
loading instructi? onons Page 4).
programme, press the Start button 1. Upon the left-hand side of the rack.
for about 5 sec,ond unstil the Start 2. Upside-down, towards the centre of
indicator lamp switches off. the rack.
Select a new programme using the 3. Upside-down, towards the left side.
programme selector knob and Cutlery basket:
press the Start button. The cutlery basket can be removed
Note: if the dishwasher is switched off to increaseC) av ( ailable space.
during a wash programme, when Some models are provided with
switched on again it will resumeRa thcke was heihght adjustment:a gridD () that can be fitted onto
cycle from where it was interrup(The dishwasted.her is delivered with the upper the cutlery basket.
Only open the dishwasher door ifrack in the t op position).
strictly necessary during a waTshhe ra cyclcke height can also be changed D
and exercise maximum caution.wh en loaded.Glass holder:
Danger of scalding from steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the End (Fin) indicator lampC
(if fitted) switches on(fo r about
30 min..)
Please read the user instructions carefully. |
ACEC
BAUKNECHT
