Troubleshooting Guide
Tips and advice Before starting a wash programme,Croc kery still dirty after washing:
make sure that the spray arms can turn
Arrange crockery so that items do not Was the crockery loaded properly?AFTER-SALES
touch each other. Arrange large freely and are not impeded by crockery Crockery must be loaded facing
or cutlery.
crockery in the lower rack and smaller downwards; this is important, especially SERVICE
crockery in the upper rack.Only switch off the dishwasher once the for large items of crockery.
If after carrying out the above checks
?Star?t indicator lamp has switched off.
Load cups at an angle to facilitate The water jets must spray the entire the malfunction persists or appears
If the dishwasher is switched off during a
water drainage.surface of all items.again, turn the appliance off and turn
wash cycle, when switched on again it
Make sure that crockery and cutlery are
Generally speaking, place cutlery inwi thll resue me the cycle from where it was off the water supply tap, then call
arranged properly.our After-Sales Service (see guarantee).
basket with the handles positioned interrupted without having to start it
Please specify:
downwards, but ensure that any sharagaip n. Have you selected the correct programme?
The nature of the fault.
knives and forks that might cause Did you use too much or too little
injury are placed in the basket with the detergent? (The use of poor qualit y The appliance type and model.
handles positioned upwards.detergents may result in less effect Thivee se rvice code (the number after
shing).the word Service on the adhesive
Make sure the water jet can reach all If a fault occurs, before contacting ouwar rating plate) inside the door
After-Sales Service, make the following
loaded items and that the spray arms Are the filters clogged or incorrectly on the right-hand side.
checks to try and remedy the problem:
turn freely.assembled? (See ?Care and Maintena?nce
The dishwasher is not working:
Important Is the plug properly inserted in the wall chapter in the user instructions).
Are the spray arms blocked or the nozzles
Fill the detergent dispenser and chsocketeck ?
clogged? (See ?Care and Maintena?nce
the salt and rinse aid level. Is there a power failure?
Is the dishwasher switched on?chapter in the user instructions).Your full address and
Do not use the appliance for items not
Has the Start button been pressed?Is the lower spray arm correctly fitteteled?phone number.
suitable for washing in a dishwasher,
Has the delayed start timer been set Is th(if e salt container cap (water softening
for example: wooden items, aluminium,
fitted)?system) screwed down?
plastic utensils, tin, hand-decorated
crockery (unglazed), silver cutlery. Is the water supply tap on? Marked crockery:
Is the flow of water obstructed by
Is the water hardness level selector not
Do not put liquid fat in the dishwasher
impurities? If so, close the water supply properly adjusted? ?Fil(Seline g the salt
(e.g. oil used for frying) or candleta wap, dex.tach the water hose and clean the
containe? ir n the user instructions).
If a fault occurs or you wish to chfaniltgee r. Then re-connect the water hose to
Is the salt container emp?tFilly? (Seeing
the current programme, press the the tap and open the water tap once
the salt cont?ai inne thr e user
?START ? button for about 5 seconds again.
instructions).
until the Start indicator lamp switcheAre ts he filters clogge?Cad? (Sre aneed
Was insufficient detergent used? (See
off.Maintenance? chapter in the user
?Filling the detergent di? inspe thnsee r
instructions).
If regeneration salt is to be added,
user instructions).
Is the door closed properly?
immediatel sty art a wash programme
Is a fault indicated? Marked glasses and cutlery:
in order to eliminate any residual salt
(The Start indicator lamp flashes). Was too much rinse aid used? (See
(rinsing alone is not sufficient).
Start the programme again from the ?Filling the rinse aid di? inspe thne useser r
Sometimes even though the instructions).
beginning: press the Start button for
regeneration salt container has been
about 5 seconds, until the Start Noteindica: with some tor models, when the Start button
filled, the corresponding indicator lamp
lamp switches off.is pressed a pre-wash cycle precedes the
(if fitted) will light up during the first
Select a new programme and press tactuhe al wash programme; this regenerates the
wash cycle after filling with salt.
Start button.water softening system.
Please read the user instructions carefully. |
ACEC
BAUKNECHT
