Before using the dishwasher, read the user instructions!
GB
GSFE 2688Quick Reference Guide
Wash cycle
On / Off button
Programme
Pre-RinseWashingDrying
end
Programme selector
Options
3)
Time and failure display
Indicates in hours the time remaining until the start of
the wash cycle. Switches off at programme start and
indicates the remaining time in hours and minutes.
On / Off button
?F....? Information for the After-Sales Service
Switches ?on? when the dishwasher is
operating. Flashes when a fault occurs.
?Delayed start? buttons
Switches off at the end of the programme.
The wash cycle can be programmed to start after 1 -
24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
IndicatorsThe dishwasher will start at the set time.
Add regeneration salt?Half Load? button
Only add regeneration salt immediately This function can be used with any programme.
before starting a wash programme.The indicator lamp switches on. The wash cycle is
activated for the upper or lower rack only.
Add rinse aidWhen washing without the top rack, press the
?Half Load? button (LED alight).
2)
Programme chartDetergentConsumption3)
ProgrammesLoading instructionsABLitreskWhMinutes
Automatic programme recommended for
Auto Normal50-60°Croutine washes, with dried-on food (for XX11-161.10-1.5090-120
example for EN 50242).
Pre-RinsecoldCrockery to be washed later.--4.00.0314
Lightly soiled crockery, with
Rapid 30 min40°Cno dried-on food.X-10.00.6530
1)
Eco50°CNormally soiled crockery.XX14.01.05120
4) 5)Normally or heavily soiled crockery, with
Hygiene +additional antibacterial action.XX13.01.50105
Recommended programme for heavily
Intensive70°Csoiled crockery, especially suitable for XX14.01.70140
pans and saucepans.
1)Reference programme for energy label in 4)The bacteria removal efficiency has been tested
compliance with EN 50242 regulations;by the Institut Pasteur de Lille (France), based on
2)Refer to ?User instructions?;the NF EN 13697 standard of November 2001.
3)Values may vary in relation to usage, e.g.: 5)Programme interruption (e.g. the door being
different loads, water temperatures - above or opened) may compromise the result of the
below 15°C - as well as water hardness and power antibacterial rinse.
supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN/Standard loading comparison test, contact the following address:
[email protected]?.
5019 496 90335
(We reserve the right to make technical modifications)
BK/I/B/GB
ACEC
BAUKNECHT
