Quick Reference GuideGB
Upper rack
Daily Check ListLower rack
1. Arrange crockery so that items do
Crockery holders:
not touch each other.
2. Load cups at an inclination to Down: cups and long-stemmed
facilitate water circulation.glasses.
3. In general, place cutlery in the basket
Up: plates.
with the handles positioned
downwards, but ensure that any
sharp knives and forks that might
cause injury are placed in the basket
with the handles positioned upwards.
4. Make sure the water jet can reach
all loaded items and that the spray
arms turn freely.
5. Turn on the water supply tap before
starting the dishwasher.Cutlery holder for long utensils:
Up: glass holder (gently lift up and
Important:
Switch off the dishwasher: once the release).Half Load:
?Start? indicator lamp has Down: large cutlery (gently lift up).
Loading the lower rack only:
switched off. Place knives with blades facing
greater washing power, especially for
If you switch off the dishwasher
downwards.
during a wash cycle, when plates and saucepans.
switched on again the dishwasher
resumes the cycle from where it Cutlery basket:
was interrupted.The cutlery basket can be removed to
If a fault occurs or you wish to
increase available space.
change the current programme, Half Load:
press th?e START ? button for about If only the upper rack is to be filled,
5 seconds until the Start indicator
remove the cultery basket from the
lamp switches off! Refer to the
Glass holder:
?Troubleshooting Guide? in these lower rack and place it in the upper
user instructions to remedy any The glass holder can be moved one.
problems.sideways.
If a regeneration salt is to be Below: small glasses.
Height adjustment:Plate holders:
added, IMMEDIATELY start a Above: long-stemmed glasses.
(The dishwasher is delivered with the The plate holders may be
washing programme, in
upper rack in the top position).removed to increase available
order to eliminate any
space.
residual salt.
To remove: pull the handle
If a fault occurs or you wish to The rack height can also be changed
change the current programme, when loaded.upwards.
press the ?START ? button. To reposition: simply insert in the
To lower: pull out the two side
Sometimes even when the required position (normal or
regeneration salt container is full, handles and gently lower the rack.
crosswise).
the corresponding indicator To raise: pull up the two side
lamp may illuminate during the
handles until the rack clicks into
first wash cycle.
place.
The rack must be level on both
sides. |
ACEC
BAUKNECHT
