94017-gb.fm5 Page 19 Wednesday, September 26, 2001 6:15 PM
CONNECTIONS
1) ELECTRICAL CONNECTIONS2.2 Non-polarized plugs (e.g. 2 pin with side
?Warning - this appliance must be earth contact)
earthed?The wire which is coloured GREEN AND
YELLOW must be connected to the earth
This appliance is normally supplied with a
contact. The other two wires should be
mains lead having a plug fitted in the factory
connected to the two pins, irrespective of
which has been checked for correct earth
colour.
continuity.
If the fitted plug is not suitable for your socket
3) FUSE REPLACEMENT
outlet, or if the machine?s mains lead is not
fitted with a plug, you should fit a suitabIf the mainle new, s lead of this appliance is fitted with
good quality plug by following the instructioa BS 136ns in 3A 13 amp fused plug, replace the
(2) below.fuse only with an A.S.T.A. approved type
conforming to BS 1362 and proceed as follows:
Any unsuitable plug should be cut off and
disposed of in order to avoid a possible shock
hazard should it be inserted into a socket.
2) CONNECTION TO A REWIRABLE
PLUG - to be carried out only by a
qualified electrician
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - ?NEUTRAL? (?N?)
BROWN - ?LIVE? (?L?)
GREEN AND YELLOW - ?EARTH? (?E?)
To fit a new plug, proceed as follows:
2.1 Polarized Plugs (e.g. 3 pin, 13 amp plug
conforming to BS 1363A)
1. Remove the fuse cover (A) and the fuse (B).
a. The GREEN AND YELLOW wire must be
2. Fit the replacement 13 A fuse into the fuse
connected to the terminal in the plug which
cover.
is marked with the letter ?E? or by the Earth
symbol or coloured yellow or green3. andRefit b oth into the plug.
yellow.For all other types of plug, the supply socket
b. The BLUE wire must be connected to the should be protected by a 16 A fuse or circuit
terminal which is marked with the letbreater ?N? ker at the distribution board.
or coloured black.
c. The BROWN wire must be connected to the
terminal which is marked with the letter ?L?
or coloured red.
19 |