Before using the dishwasher, read the user instructions!
GB
GSIP 6798Quick Reference Guide
Wash cycle
Programme selector knob
Programme
Pre-RinseWashingDrying
end
Options
On / Off button3)
Time and failure display
Indicates in hours the time remaining until
the start of the wash cycle. Switches off
when the programme starts and indicates
the time remaining in hours and minutes.
Start button
?F....? Information for the After-Sales
Switches ?on? when the dishwasher is Service
operating. Flashes when a fault occurs.
Switches off at the end of the programme.?Delayed start? buttons
The wash cycle can be programmed to start
after 1 - 24 hours. With each successive touch
of the button, the delayed start indicator
Indicatorsincreases by 1 hour, and after 24 returns to
00. Then press the Start button. The
dishwasher will start at the set time.
Add regeneration salt
Only add regeneration salt immediately ?Half load? button
before starting a wash programme.This function can be used with any programme.
The indicator lamp switches on. The wash cycle
Add rinse aidis activated for the upper or lower rack only.
When washing without the top rack, press
the ?Half Load? button (LED alight).
2)3)
Programme chartDetergentConsumption
ProgrammesLoading instructionsABLitreskWhMinutes
Pre-RinsecoldCrockery to be washed later.--4.00.0314
Light soiling, for example glasses
Glass40°CX-10.00.8055
and cups.
Lightly soiled crockery with no
Rapid 30 min40°CX-10.00.6530
dried-on food.
Eco50°CNormally soiled crockery.X-10.01.3085
1)
Standard50°CNormally soiled crockery.XX13.01.05145
Normally or heavily soiled
4) 5)
Hygiene +crockery, with additional XX13.01.50115
antibacterial action.
Heavily soiled crockery, especially
Intensive70°CXX14.01.70150
pots and pans.
1)Reference programme for energy label in compliance with 4)The bacteria removal efficiency has been tested by the
EN 50242 regulations;Institut Pasteur de Lille (France), based on the NF EN
2)Refer to ?User instructions?;13697 standard of November 2001.
3)Program data obtained in conformity with European 5)Programme interruption (e.g. the door being opened)
standard EN 50242. Values may vary in relation to usage, e.g.: may compromise the result of the antibacterial rinse.
different loads, water temperatures - above or below 15°C -
as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
[email protected]?.
5019 496 90379
(We reserve the right to make technical modifications)
BK/I/B/GB
ACEC
BAUKNECHT
