Chapter 8 Using the GT-PRO Connected to the FC-200
Switching the Effect On and Off with Selecting the Effect to Be Switched
On and Off With the Pedals
the FC-200Os Pedals (Manual Mode)
The GT-PRO features a Manual mode, in which the pedals on 1. When you press PARAMETER [] [] while
the FC-200 are used for switching specified effects on and off.
Manual mode is on, the screen for the pedals used to
In Manual mode, you can switch effects on and off without change the settings is displayed.
changing the patch number.fig.08-0160d
(Example)
Switching to Manual Mode
fig.08-0140
22. Rotate the VALUE dial to select the effect to be
assigned to the pedal.
3. Repeat Steps 1 and 2 as needed.
4. Press [EXIT] to return to the Play screen.
ValueExplanation
4 1OffNot used.
Preamp Ch A/BSwitches between Preamp channel A and B.
Solo On/OffSwitches the Preamp SOLO on and off.
1. Press [SHIFT] so the indicator is lighted.FX-1 On/OffSwitches the FX-1 on and off.
Comp On/OffSwitches the COMP on and off.
2. Press PARAMETER [].
Wah On/OffSwitches the WAH on and off.
The GT-PRO switches to Manual mode, and the
Loop On/OffSwitches the LOOP 1/2 on and off.
following appears in the display.
Switches the OVERDRIVE/DISTORTION
fig.08-0150dOD/DS On/Off
on and off.
Switches the PREAMP/SPEAKER on and
Preamp On/Off
off.
EQ On/OffSwitches the EQ on and off.
FX-2 On/OffSwitches the FX-2 on and off.
Delay On/OffSwitches the DELAY on and off.
3. Press the FC-200Os [MODE] button to switch the FC-200
Chorus On/OffSwitches the CHORUS on and off.
to Control Change mode.
Reverb On/OffSwitches the REVERB on and off.
O� appears in the FC-200Os display.
Pre Loop On/OffSwitches the PRE LOOP on and off.Chapter 8
* For more on the FC-200Os Control Change mode, refer to the Amp Ctl1 On/OffSwitches the AMP CTL 1 on and off.
FC-200 OwnerOs Manual.Amp Ctl2 On/OffSwitches the AMP CTL 2 on and off.
MANUAL On/OffSwitches the MANUAL on and off.
4. To switch Manual mode off, press [EXIT].
TUNER On/OffSwitches the TUNER/BYPASS on and off.
* You can also switch Manual mode off by pressing [SHIFT]
Switches Hold recording (dubbing) on and
and then PARAMETER [].Hold Dly Rec/Duboff when OHold� (p. 32) is selected for the
delay type.
5. Press the FC-200Os [MODE] button one or more times to When OHold� is selected for the delay type,
Hold Dly Stop
switch the FC-200 to Program Change mode.the performance is instantly stopped.
* For more on the FC-200Os Program Change mode, refer to the Switches to the next higher patch number in
Patch Num. Incthe same bank as the currently selected
FC-200 OwnerOs Manual.
patch.
Switches to the next lower patch number in
Patch Num. Decthe same bank as the currently selected
patch.
Patch Bank IncSwitches to the next higher bank number.
Patch Bank DecSwitches to the next lower bank number.
85 |
ACEC
BOSS
