Drive MechanismGV 94 �
50200 R/P Head assy
70400 Cassette lid opener
50210
Screw
Apply grease
UHole
(part no. 75988 061 7800)
Fig. 8.34VPin
Apply grease (part no. 75988 061 7800)
to the bottom of the clamp
Fig. 8.36
8.13Tape Drum
� Undo two screws (Pos. 30000), remove the stator (Pos. 22000) and
the tape drum earth spring (Pos. 11600, Fig. 8.37).
� When turning the mechanism upside down now, the carbon chip
(Pos. 11500) will fall out (Fig. 8.37).
� Undo two screws (Pos. 30000) and remove the rotor (Pos. 21000,
Fig. 8.37).
� Undo the three screws (Pos. 10400) at the bottom of the mechanism
and take the complete tape drum (Pos. 11000) out (Fig. 8.39).
30000 Screws
Flexible cable
Fig. 8.35
8.12R/P Head Assy (Pos. 50200)
� Undo the screw (Pos. 50210), press the R/P head assy
(Pos. 50200) in the direction of the arrow as shown in Fig. 8.36 and
remove it upwards.22000 Motor stator
Note: Align the holeU of the R/P head assy (Pos. 50200) and pin
V on the mechanism chassis.
30000
Subsequently, adjust the tape path and tracking position
Screws
(X value, refer to point 9. aAdjustmentsO).21000
Motor rotor
11600
Earth spring,
tape drum
11500 Carbon
chip, tape drum
11000
Tape drum
Fig. 8.37
5 - 28GRUNDIG Service |
ACEC
GRUNDIG
