GX-15/15R Amplifier
1234567891011 1213
1: INPUT:Connect your guitar here using amidrange output; turning it to the right increases
shielded instrument cable.the midrange output. The Mid control allows for
OVERDRIVE CHANNEL: A high gain channel19dB of boost or cut at 900Hz.
giving you sounds from a slight edge to serious8: HIGH:Adjust the high frequency output level
overdrive.with this control: in the center position the high fre-
2: GAIN:This control sets the amount of com-quency output will be Oflat� (no boost or cut).
pression and distortion from the amplifier. With theTurning the control to the left reduces the high fre-
control towards far left, the sound will have a thickquency output; turning it to the right increases the
compressed quality. As you turn the control to thehigh frequency output. The High control allows a
right the amount of distortion increases. CrateOstotal range of 23dB of boost or cut at 5kHz.
exclusive OFlex Wave� circuitry uses sequential9: REVERB LEVEL:(GX-15R only) Adjust the
cascading gains to deliver distortion which is richamount of Reverb effect with this control: in its full-
in harmonics and Otouch sensitive.� Use this conleft position the signal will be Odry� (without any-
trol along with the Level (#3) to create a wide varireverb). As you turn the control to the right the-
ety of sounds.amount of reverberation increases.
3: LEVEL:This control sets the output volume10: HEADPHONES: For private practice ses-
level from the Overdrive channel: in the far-leftsions, plug a pair of stereo headphones into this
position there will be no output; as you turn thejack. The internal speaker is disconnected when-
control to the right the output increases. Use thisever headphones are being used.
control along with the Gain control (#2) to create a11: EXTERNAL SPEAKER: You may connect the
wide variety of sounds.GX-15/15R to an external speaker with a rated
4: OVERDRIVE SELECT: When this pushbuttonimpedance of at least 4 ohms using this jack. The
switch is pressed in the Overdrive channel isinternal speaker is disconnected whenever an
engaged. The clean channel is selected when thisexternal speaker is used.
switch is out.
CLEAN CHANNEL: A normal gain channel
designed to give you crystal clear sounds to medi-WARNING: DO NOT attempt to use head-
um distortion.phones in the Speaker jack! Permanent
hearing damage could result!
5: LEVEL:This control sets the output volume
level from the Clean channel: in the far-left posi-
tion there will be no output; as you turn the control12: ON LED:This LED will glow when you turn on
to the right the output level increases. the GX-15/15R, showing you that the amplifier isThe far right
setting is maximum output - as you increase theactivated and ready to play.
level, roll back the Low control (#6).13: POWER: This heavy-duty rocker switch is
EQUALIZATIONused to turn the amplifier ON in the up position, off
6: LOW:Adjust the low frequency output levelin the down position. The ON LED (#12) works
with this control: turning the control to the leftwith this switch as a visual indicator.
reduces the low frequency output; turning it to the14: POWER CORD: (Rear panel, not shown: This
right increases the low frequency output. The Lowheavy-duty, grounded, three-wire power cord is to
control allows a total range of 25dB of boost or cutbe plugged into ONLY a safely-wired, grounded
at 80Hz. Due to the massive amount of low end120 volt, 60 cycle AC power outlet. DO NOT
available, you may want to Oroll off� the bass atattempt to defeat the ground connection of this
high volumes.
cable! If your GX-15/15R was purchased outside
7: MID:Adjust the mid frequency output level withof the United States, see the unitOs rear panel for
this control: the center position is Oflat� (no boostits power rating and follow the above guidelines.
or cut). Turning the control to the left reduces the |
ACEC
CRATE
