MAINTENANCE
Gear housingMaintenance schedule
Below you will Ţnd some general maintenance instructions. If
you need further information please contact your service
workshop.
There is a grease nipple and a plug for Ţlling lubricant on the
gear housing. Use a grease gun to Ţll with grease. New Daily maintenance
machines are Ţrst Ţlled with grease after approximately 20
hours of operation, and subsequently approximately every 60 12
hours of operation. Use Husqvarna?s special grease, no.
503 98 96-01.
1 Check that the blades do not move when the engine is
idling or when the choke is in the start throttle position.
2 Check that the hand guard is not damaged. Replace the
guard if damaged. (HA 110)
Weekly maintenance
CAUTION! The gear housing must not be Ţlled completely
with grease. The grease expands as the machine heats up
during operation. If the gear housing was completely Ţlled 2
1
with grease it could damage the seals and lead to leakage of
grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
1 Fill the gear housing with grease. New machines are Ţrst
Cleaning and lubrication
Å¢lled with grease after approximately 20 hours of
operation, and subsequently approximately every 60
hours of operation.
2 Check that the screws that hold the blades together are
Clean any resin and plant residue from the blades using correctly tightened.
cleaning agent 531 00 75-13 (UL22) before and after using
the machine.
Lubricate the blade bars with special grease, part no. 531 00
75-12 (UL 21) before long periods of storage.
Technical data
Technical dataHA 110HA 850
Weight
Weight, Lbs/kg
2,02,4
Blades
Length, mm550550
Blade speed, cuts/min41844184
10 - English |
ACEC
HUSQVARNA
