HPD-10_e1.book 29 Z8 ???- ??e?? xý~
U xý9=?p?? Â
Error Messages/Troubleshooting
This section lists the messages (error messages) that the HandSonic 10 produces and explains the meaning of each
message, giving you to appropriate action to take.
MESSAGEMEANINGWHAT TO DO
midi offline!MIDI Cable was disconnected, or Check MIDI connections/cables.
communication with external MIDI device was
interrupted.
midi buf full!Too much MIDI information was received at Verify connections, and the type of MIDI
once and could not be processed correctly. information you are sending.
midi rx error!The HandSonic 10 did not receive a MIDI Re-transmit the message again.
message correctly.
bulk rx error! The HandSonic 10 did not receive BULK MIDI Re-transmit the message again. If the problem
data correctly. continues, thereOs a problem with the data
being transmitted to the HandSonic 10.
bulk checksum!Checksum value of a System Exclusive Correct the checksum value.
message was not correct.
battery low!The internal battery, used for maintaining data Contact your dealer, or Roland service to
in the user memory, has become weak.have it replaced.
Troubleshooting
Before contacting a local Roland service center, be sure you have read this manual in its entirety.
1.NO SOUND?determines if the patterns play back at their own
Double check all audio connections, volume controls on individual, pre-set tempos, or at the tempo set by the
the HandSonic 10 or external amplifier.Metronome itself. See page 15.
2.OVERALL SOUND OF A KIT HAS CHANGED?6.PLAYING WITH THE STYLE GUIDE METRONOME.
Did you use the Control Knob to modify Tuning, Muffling Depending on the pattern chosen and the kit you are
or Effects? If you did, and you changed kits without playing, you may notice sounds drop out, or mute.
executing UNDO, then you have re-written various
7.WHEN CHANGING FROM ONE KIT TO ANOTHER, YOU
parameters in that kit. HEAR A SOUND?
For info on the Control Knob functions, see page 8. For Depending on the EFFECT assigned to a specific kit, and
info on UNDO, see page 23. For info on recalling any the length or decay, of the last sound played, this may
KITOs original factory settings, see page 27.
occur. If you play a cymbal sound, and then change the kit
3.THE [EFFECT] BUTTON IS OFF, BUT YOU STILL HEAR while you can still hear that sound, then the effects
REVERB?assigned to the new kit will be applied to that last sound.
Look at the display to see if AMBIENCE is still ON. To 8.TEMPO DELAY
turn it off, while holding [SHIFT], press the [EFFECT] button. Because of the way the Tempo Delay operates, at low
(AMBIENCE-page 8)
tempos, depending on the BEAT selection, it may not work
4.FOOT SWITCH SEEMS TO WORK BACKWARDS?as you expect.
When using foot switches, if you hear the sound when you Also, the Tempo Delay will not follow correctly if you are
release your foot from it, this means you need to switch the using the Auto Up/Down function in COACH mode.
POLARITY, or you have not set the correct TYPE of external
trigger. See page 26.9.COACH MODE- RHYTHM CHECK AND PAD FOLLOW
If you set the BEAT to O0� or O1� the HandSonic will play
5.STYLE GUIDE METRONOME - TEMPO PROBLEMS?in 4.
a. You have set the tempo of the metronome, but the
pattern plays at a different tempo?10.ROLL
When using the Roll function set to high speeds, and
b. All the patterns play back at the same speed. depending on the sounds you are Orolling,� sometimes
Remember there is a Tempo Change parameter that
noise may occur.
29 |
ACEC
ROLAND
