CleaningThe lamps of solariums contain substances which
may pollute the environment.
Always unplug the solarium and let it cool down beforefWhen discarding lamps, please ensure that they are
cleaning.separated from the normal household refuse and that
You can clean the outside of the solarium with a dampthey are disposed of at an officially assigned place.
cloth. Make sure that no water runs into the appliance.
Do not use abrasives or scourers, or liquids such as petrol
or acetone.
You may clean the UV-A filters with white spirit sprinkled on
a soft cloth.
Replacing the sun lamps and/or UV-A filtersFor U.K. only:
In the course of time (in normal family use after some years)Fitting a different plug
the efficiency of the sun lamps will gradually decrease.
If this happens, you may increase the tanning session time orThis appliance is fitted with a BS 1363 13 Amp. plug.
have the sun lamps replaced.Should you need to replace the plug, connect the wires as
follows:
The hours counter R indicates33
the total amount of operationGreen/yellow wire to the Earth terminal (E) of the new plug.
hours. In general, it is advisableBrown wire to the Live (L) terminal of the new plug.
to replace the lamps afterBlue wire to the Neutral (N) terminal of the new plug.
750 hours (fig. 33).
Always fit the same value of fuse as that originally supplied
The UV-A filters protect youwith your appliance.
against harmful UV. For thatOnly use BS 1362 approved fuses.
reason, have a defective orAs a guide only: Appliances under 700 W can have a 3 Amp.0075000
damaged filter replaced rightfuse (red) and all others should have a 13 Amp. fuse (brown).
away.
When disposing of an old plug (particularly the moulded type
Have the sun lamps and UV-A filters replaced only bywhich has been cut from the mains cord) always remove the
authorized service personel: only these have the requiredfuse as the plug could be dangerous if ever inserted in a live
skill and dispose of the original replacement parts.socket.
Solarium does not operate as required?
If the solarium should not operate as required, this may be due to a defect. In this case do not hesitate to apply to your dealer or
to a Service Centre.
However, it is also possible that the appliance has not been installed according to the instructions or is used incorrectly.
If this is the case, you will be able to solve the problem immediately.
You may check the following section before contacting your dealer or Service Centre.
ProblemPossible cause
Solarium does not switch on.- Mains plug is not in wall socket.
- No mains power. (Please check with other appliance.)
- The lamps are still too warm to restart. (Allow the lamps to cool down for
approx. 3 minutes.)
- Ventilation was insufficient and the automatic thermal safety device has
switched the appliance off. (Remove the cause of overheating (e.g. take
towel away from ventilation opening(s)) and wait for 10 minutes before
switching on again.)
- The two upper casings L have not been folded out. (Please refer to
section "Making the solarium ready for use".)
- The section switches Q are not in the required position.
The power fuse switches the mains- Check the fuse to which the solarium has been connected.
power off when switching on or whileThe proper type for your solarium is a 13 A or 16 A normal fuse or a slow
using the solarium.reacting automatic fuse.
The browning is not according to your- You use an extension cord which is too long and/or does not allow the
expectations.required power levels. Please apply to your dealer.
In general, we advise not to use an extension cord.
- You followed a course which is not the most appropriate for your skin type.
- The operational distance is larger than indicated.
- After using for a long time the UV production of the lamps decreases.
(With normal use this will not be noticeable before years.)
You may compensate for this effect by selecting longer treatment times or
have the sun lamps replaced.
10 |
ACEC
PHILIPS
