Model information table
ModelDCR-HC23EDCR-HC24EDCR-HC26DCR-HC26EDCR-HC35E
US, CND, E, ARNE, E, AUS, CH,
DestinationAEP, EE, NEAEP, UK, EE, NEAEP, UK, EE, NE
BR, KRHK
Color systemPALPALNTSCPALPAL
DV InterfaceOUTOUTIN/OUTIN/OUTIN/OUT (Note)
Remote commander�a��a
Cradle (Handycam Station)����a
Note:DV Interface on the Cradle (Handycam Station)
Abbreviation
AR : Argentine model
AUS: Australian model
BR : Brazilian model
CH : Chinese model
CND: Canadian model
EE : East European model
HK : Hong Kong model
J: Japanese model
JE : Tourist model
KR : Korea model
NE : North European model
SAFETY-RELATED COMPONENT WARNING!!ATTENTION AU COMPOSANT AYANT RAPPORT
� LA S?CURIT?!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITHLES COMPOSANTS IDENTIF?S PAR UNE MARQUE 0 SUR LES
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTSDIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES SONT
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESECRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT. NE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERSREMPLACER CES COMPOSANTS QUE PAR DES PIéSES SONY
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTSDONT LES NUM?ROS SONT DONN?S DANS CE MANUEL OU
PUBLISHED BY SONY.DANS LES SUPP?MENTS PUBLI?S PAR SONY.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
1.Check the area of your repair for unsoldered or poorly-soldered5.Check the B+ voltage to see it is at the values specified.
connections. Check the entire board surface for solder splashes6.Flexible Circuit Board Repairing
and bridges.? Keep the temperature of the soldering iron around 270°C
2.Check the interboard wiring to ensure that no wires areduring repairing.
"pinched" or contact high-wattage resistors.? Do not touch the soldering iron on the same conductor of the
3.Look for unauthorized replacement parts, particularlycircuit board (within 3 times).
transistors, that were installed during a previous repair. Point? Be careful not to apply force on the conductor when soldering
them out to the customer and recommend their replacement.or unsoldering.
4.Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
DCR-HC23E/HC24E/HC26/HC26E/HC35E_L1
N 3 N |
ACEC
SONY
