[Aging Mode]Y Display at an error occurred
This mode can be used for operation check of CD section and tape1) Display of the error count
deck section.(1) Press three buttons ofp , [ENTER/NEXT], and [CDESYNC]
CD section and tape deck section work in parallel.simultaneously.
Y If an error occurred:(2) Display of the error count following as below.
The aging operation stops only an error occurred sections and
display then status.Display
Y If no error occurs:
The aging operation continues repeatedly.
EMCEDC
****
Procedure:
1. Set disc in DISC1 tray.
2. Load the tapes into the decks A and B respectiNotes:vely.
3. Press the [PLAYEMODE] button to set the OALL DISCS�EMC mode,**:The number of mechanical error.
EDC: The number of no disc error after chucking the disc.
and press the [REPEAT] button to OREPEAT� off.**
4. Press the [FUNCTION] button to select the function OCD�.
2) Display of mechanical error
5. Press three buttons ofp , [ENTER/NEXT], and [DISCESKIP/
EX-CHANGE] simultaneously.
Display
6. The aging mode is activated, if the indicator of disc tray num-
ber on the fluorescent indicator tube is blinking.
7. To exit from the aging mode, press the1/u button to turn the
EM##$$&&
**
power OFF and operate the cold reset. (Refer to the OMC Cold
Reset�)
Notes:
1. Display at the Aging Mode
: The number of mechanical error.(O00� is latest one)
Y Display operating state of CD section and tape deck section al-**
(Press the [PLAYEMODE] button to changes next error display)
ternately.## : Not used.
Y If an error occurred, stop display which that section.$$ : Loading error. (Second figure is not used)
D: The error in the midst of close at the except mechanical trouble.
2. CD SectionE : The error in the midst of open at the except mechanical trouble.
Y Display at the aging mode is the same as the normal operation.C : The error in the midst of chuck up at the except mechanical
trouble.
Y The sequence during the aging mode is following as below.
F : The error in the midst of EX-open at the except mechanical
trouble.
Aging mode sequence (CD section) :
&&: Loading error. (Second figure in not used)
1:The error in the midst of chuck up.
2:The error in the midst of chuck down.
3:Time up of EX-open
4:Time up of EX-close.
Turn the disc tray
3) Display of no disc error
Disc1 chuckingDisplay
ED##$$&&
**
TOC read
Notes:
Play track1 for 2 seconds: The number of mechanical error.(O00� is latest one)
**
(Press the [REPEAT] button to changes next error display)
##:
01:Focus error
Play last track for 2 seconds02:GFS error
03:Set up error
$$:
00:No disc error when does not chucking retry.
02:No disc error when chucking retry to completion.
&&: The state when judged no disc error. (Second figure is not used)
1:Stop
2:Set up
3:TOC read
4:Access
5:Play
6:Pause
7:Manual search (Play)
8:Manual search (Pause)
� 12 � |
ACEC
SONY
