ENGLISH� The kettle switches off ('O' position) automatically when the water has
reached boiling point.33HD4642, HD4641, HD4638, HD4629,
4
� You can interrupt the boiling process by setting the on/off switch to 'O'.4
Introduction.HD4628, HD4627, HD4626, HD4399
.
Congratulations on acquiring your new Philips kettle! In these instructions for use youCleaning and descaling
will find all important information, so you can optimally enjoy your kettle as long asAlways unplug the appliance before cleaning it.
possible.
Do not use any abrasive cleaning agents,scourers etc.to clean the kettle.
General description.Never immerse the kettle or its base in water.
1) On/off switch (I/O)7
Cleaning the kettle11
2) Pilot light
1 Clean the outside of the kettle with a soft,damp cloth moistened with warm
3) Lid5
water and some mild cleaning agent.
4) Spout
5) Water-level indicatorScale is not harmful to your health but it may give your drink a powdery taste.The
6
6) Base (HD4399 has no base)scale filter prevents scale particles from ending up in your drink. Clean the scale filter6
7) Scale filter (HD4642, HD4629, HD4628 and HD4627 only)regularly.
HD 4638
Important.2 The filter can be cleaned (HD4642 and HD4628 only):
HD 4642, HD 4641
Read these instructions for use carefully before using the appliance and save them for� by taking it out of the kettle and gently brushing the filter with a soft nylon
33
future reference.brush under a running tap,or..(fig.5).4
4
� by leaving it in the kettle when descaling the whole appliance,or...1
� Check if the voltage indicated on the base of the kettle corresponds to the
� in the dishwasher.
local mains voltage before you connect the appliance.2
� Only use the kettle in combination with its original base.Descaling the kettle
� Always place the base and the kettle on a dry,flat and stable surface.Regular descaling will prolong the life of the kettle.
� Keep the cord,the base and the appliance away from hot surfaces.
In case of normal use (up to 5 times a day), the following descaling frequency is7
� Do not use the appliance if the mains cord,the plug,the base or the appliance73.0max1.73.0max1.7
recommended:pt lpt l
itself is damaged.
-Once every 3 months for soft water areas (up to 18 dH).
� If the mains cord is damaged,it must always be replaced by Philips,a service2.012.0
-Once every month for hard water areas (more than 18 dH).51.051.0
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.1 Fill the kettle with water up to three-quarters of the maximum level and bring1.01.0
0.90.5
� Do not immerse the appliance or the base in water or any other liquid.the water to the boil.min0.9min0.5
� The kettle is only meant for boiling water.Do not use it to heat up soup or
2 After the kettle has switched off,add white vinegar (8% acetic acid) to the
other liquids or jarred,bottled or tinned food.6 6
maximum level.
� Boiling water can cause serious burns.Be careful when the kettle contains hot
water.3 Leave the solution in the kettle overnight.HD 4628, HD 4626
HD 4629, HD 4627
� Never fill the kettle beyond the maximum level indication.If the kettle has
4 Empty the kettle and rinse the inside thoroughly.
been overfilled,boiling water may be ejected from the spout and cause
3
scalding.5 Fill the kettle with clean water and boil the water.4
� Do not open the lid while the water is boiling.Be careful when you open the
6 Empty the kettle and rinse it with clean water again.
lid immediately after the water has boiled:the steam coming out of the kettle
is very hot.� Repeat the procedure if there is still some scale in the kettle.
� Avoid touching the body of the kettle,as it gets very hot during use.Always lift
You can also use an appropriate descaler. In that case, follow the instructions on the
the kettle by its handle.
package of the descaler.
� Keep the appliance and its cord out of the reach of children.Do not let the
mains cord hang over the edge of the table or worktop.Excess cord can beReplacement.
stored in or around the base of the appliance.
Replacement filters for your kettle can be purchased from your Philips dealer or a2
� Never fill the kettle below the minimum level to prevent the kettle from
Philips service centre.The table below indicates which filters are suitable for your
boiling dry.
electric kettle.u
� Some condensation may appear on the base of the kettle.This is perfectly1
www.philips.com4222 001 97391
normal and does not mean that the kettle has any defects.If the kettle,the base or the mains cord of the appliance is damaged,take the base
� Depending on the hardness of the water in your area,small spots may appearor the kettle to a service centre authorised by Philips for repair or replacement of
on the heating element of your kettle when you use it.This phenomenon is thethe cord to avoid a hazard.
HD 4399
result of scale build-up on the heating element and on the inside of the kettle
.
over time.The harder the water,the faster scale will build up.Scale can occurGuarantee & service
in different colours.Although scale is harmless,too much scale can influenceIf you need information or if you have a problem, please visit the Philips website at23
the performance of your kettle.Descale your kettle regularly by following thewww.philips.com or contact the Philips Customer Care Centre in your country (you
instructions given in the chapter 'Descaling'.will find its phone number in the world-wide guarantee leaflet). If there is no
Customer Care Centre in your country, turn to your local Philips dealer or contact
Boil-dry protection
the Service Department of Philips Domestic Appliances and Personal Care BV.
This kettle is equipped with boil-dry protection.This device will automatically switch
the kettle off if it is accidentally switched on when there is no water or not enough
water in it.The on/off switch will stay in 'on' position and the pilot light, if available, willKettle typeFilter type
stay on. Set the on/off switch to 'O' and let the kettle cool down for 10 minutes.The
HD4628, HD4627HD4966
kettle is ready for use again.
HD4629HD4970
Before first use.
HD4642HD4960HD464245
� Remove stickers,if any,from the base or kettle.HD4641
� Place the base on a dry,stable and flat surface.
� Adjust the length of the cord by winding it round the reel in the base.Pass the
cord through one of the slots in the base (fig.2).HD4627
HD4629
Before using the kettle for the first time:
1 Rinse the kettle with water.
HD4628
2 Fill the kettle with water up to the maximum level and let it boil once (seeHD4638
HD4399
'Using the appliance').
3 Pour out the hot water and rinse the kettle once more.
Using the appliance.
1 Fill the kettle with water either through the spout or through the open lid (fig.
3).
2 Close the lid.
Make sure that the lid is properly closed to prevent the kettle from boiling dry.
3 Place the kettle on its base,put the plug in the wall socket and set the on/off
switch to 'I' (fig.4).
The kettle starts heating up. |