Section 1
Installation
1-1. Operating Environment1-2-2. Power Cord
ww
Do not put this unit in a place subject to excessive oilThe power cords are not supplied with HDS-V3232, the
painting, steam, moisture, or dust. This may cause a fire orcontrol panels. Be sure to use the power cords that are
electric shock.applicable to the places in the world.
. Install the unit in a well ventilated place to prevent an
temperature rise in the unit. Never cover the ventilationThe plug holder is not used for the control panels.
holes of the outer frame.
. Never install the unit near a heat source because the For the customer in the U.S.A. and Canada
Required Parts
environmental temperature during operation should be
1 Power Cord, 125 V 10 A (2.4 m) : 1-557-377-11
5 dC to 40 dC.
2 Plug Holder B (Black) : 2-990-242-01
1-2. Power SupplyAC inlet
12
1-2-1. Power Specifications
Supply voltage: 100 to 240 VAC ? 10 %
Power frequency: 50/60 Hz
Current consumption: 7.0 A (max.)n
Power consumption: 700 WFor the customer outside of the area as shown above,
Inrush current: 20 A (max.)please consult with local SonyO s sale/service office.
n
Since the inrush current during the power-on sequence is
20 A (max.), the capacity of the AC power must be
commensurate with an inrush current of 20 A (max.). If
the capacity of the AC power is not adequately large, the
breaker of the AC power on the supply side will operate or
the unit will not operate normally.
HDS-V3232 MM1-1 (E) |
ACEC
SONY
