2-7. Cassette Tape Manual Ejection
2-7. Cassette Tape Manual EjectionIf the left mentioned operations are disabled, perform the
following procedures.
1. Turn off the power switch.
2. Open the cover of the outside panel shown in the1. Remove the front lid and outside panel.
figure.(Refer to Section 2-4.)
3. While pushing the gear inside using a Phillips screw-n
Even a slight bend causes a short life of the flexible
driver, turn the gear counterclockwise until the front
lid lock gets released.board, therefore use extreme care to handle it.
4. The front lid opens and the cassette tape can be
2. Disconnect the antenna flexible board from the
ejected.
connector of the CCM-33B board.
3. Extract the antenna flexible board from the gap
between the shield case and the shield plate. (Refer to
Figure 1.)
4. Remove the DC-DC converter in the arrow direction.
DC-DC converter Antenna flexible board
Antenna
flexible board
Connector
Shield case
Outside
panelShield plate
Figure 1
CoverRE-140 board
CCM-33B
1board
2
Front lidTurn while pushingGroove
(Counterclockwise)
Cassette
compartment
n
Do not turn the gear after the front lid lock was released.Connectors of
MB-877 board
Closing the front lid5. With the lid of the cassette tape raised, raise the white
The front lid cannot be closed and locked in the above
lock roller of the cassette compartment to set it to the
status.raised status. (For details of how to raise the cassette
Perform either step below to close and lock the front lid.
compartment, refer to Section 2-6.)
(1) Turn on the power switch.6. Remove the cassette tape carefully preventing damage.
(2) Turn the gear slightly clockwise.
n
When installing the DC-DC converter, use care about its
position and direction, and insert the RE-140 board along
the groove of the chassis.
2-20HDW-F900 P1 |
ACEC
SONY
