Troubleshooting table
The engineThe machine
does notThe engine stuttersstarts but does
or loses power
startnot cut properly
Make sure the STOP switch is on I.
Y
Make sure that the fuel tank is at least 25%
full.YY
Make sure the air filter is clean.
YY
Remove the sparkplug, dry and clean it,
then return it to its place. If necessary,
YY
replace it.
Check and if necessary adjust the screws
Y
on the carburetor
Change the fuel filter. Contact your supplier.
Y
Follow the correct procedure for assembly
of the cutting accessories.Y
Make sure the metal accessories are sharp,
and contact your supplier if necessary.Y
The engine continues to have problems: contact your authorized supplier.
Environmental information
This section contains information useful for main-3. PERIODS OF PROLONGED DISUSE
taining the characteristics of eco-compatibilityAlways empty the fuel tank with the same precau-
included in the origin design of the machine, andtions used in filling it.
as regards proper use and disposal of oil and
fuel.4. DISPOSAL
Do not dispose inappropriately of the machine
1. DESIGNwhen it is no longer usable. Deliver it to an
In the design stage, care was taken to develop anauthorized organization for proper disposal in
engine with reduced consumption and low emis-compliance with the regulations in force.
sions of noise and pollutant exhaust fumes.
2. USE OF MACHINE
The operations of filling the tank with the fuel mix-
ture should be carried out in such a way as to
avoid spilling fuel and contaminating the soil and
environment.
ENGLISH - 8 |
ACEC
PARTNER
