GBPROGRAMME CHART
DYNAMIC SENSE: Energy savings and good wash results
The two sensor-controlled programmes are recommended for
routine washes. The two sensor-controlled programmes are
recommended for routine washes.
Separate sensors gauge turbidity and particles in order to determine
the degree of soiling of the wash water. In accordance with values
measured, a microprocessor establishes optimum water, energy and
time consumption. Optimum wash results are thus achieved using
only those resources strictly required.
Water tap indicatorProgramme progress indicator Delayed start button
Turn on the tap.Pre-rinseStarts the dishwasher at the set time. It is
Only lights up for programmes with prewash (the
possible to programme a delay of 3 - 6 - 9 hours.
Spray arm block indicatorsymbol ?+? in the table below indicates that
detergent must be added). Start button indicator lamp
Release the lower spray arm.
Rinse /WashingSwitches on when the dishwasher is operating.
Water stop indicatorFlashes when a fault occurs.
Drying
Switches off at the end of the programme.
?Water stop? device not working.
Switch off the dishwasher and shut off the water Programme end
On/Off Button
tap.
Rinse aid level indicatorEco-Dry Button
Add rinse aid.Dry cycle without using fans.
Salt level indicator
Add regeneration salt.
DetergentConsumption *
Programme SymbolProgramme selection andPre-rinse / WashingNormal load
and Temperaturerecommended load typesmalllargeWater EnergyTime
compartmentcompartment(Litres)(kWh)(Min.)
Recommended programme for routine washes, for crockery
Dynamic Sense Normal 40 - 55°Cwith little or no dried-on food.++
Recommended programme for heavily soiled crockery, with
++
Dynamic Sense Intensive 60 - 70dried-on food. Especially suitable for pans and saucepans.°C
Crockery to be washed later.--5.00.029
Pre-rinse
Rapid 40° CLightly soiled crockery with no dried-on food.-+13.00.8530
Lightly soiled glasses and cups.-+12.50.8260
Glasses 40° C
1)Normally or heavily soiled crockery with dried-on food.++16.01.05120
Bio 50° C
1) Reference programme for Test Institute and energy label. 5019 100 90166
*)Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures,
(We reserve the right to make technical modifications)
water hardness and power supply voltage. |
ACEC
