? Set the print gap wheel to 1 for single-part paper or 2 for two-
part paper. For a more accurate method of setting the print
gap, see the section, ?Print Gap Adjustment,? in the 5000
Series User?s Manual.
? Set the paper tension lever to 1 for single-part paper and 2 or
higher for multi-part forms.
Note
Because of humidity and the weight of the paper, you may have to
change the above settings to obtain the best print quality. For
paper specifications, see Appendix B in the 5000 Series User?s
Manual.
7. Press the TOF pushbutton on the control panel.
8. At this point the message Paper Jam may be displayed. Press the
Clear pushbutton on the operator control panel to clear this display.
9. Close the top cover.
10. Press the On Line pushbutton on the control panel. ?On Line? should
now be displayed. If a fault message is displayed, check the ?Display
Messages? section of this guide to determine the possible cause.
On Line
Status
5000 Series Quick Reference Guide19GEK-99012 |
ACEC
