TEAC HD-P2 Quick Start

Set Up Default Project SettingsInput Settings
1. Press the MENU keyThis is a two part operation consisting of top panel
2. Use the DATA wheel to scroll to System Menuswitch settings and menu settings.
3. Press the SELECT key
Top Panel
4. Use the DATA wheel to scroll to Default
Project Settings" Set the LEFT INPUT and RIGHT INPUT switches
5. Press the SELECT keyto LINE or MIC. When set to LINE, the HD-P2
6. Use the DATA wheel to scroll to the desired accepts analog input from the appropriate
setting to changeRCA jack. When seMt ICt, ot he HD-P2
7. Press the SELECT key,c hanget hes etting, accepts analog input from the appropriate XLR
press the SELECT key againjack. Note that one side (Left or Right) can
accept input from only one analog source at
8. ýepeat Step 7 for all desired settings
a time. These settings for Left and Right are
NOTEindependent of each other.
All newly created projects will use these " Set the MIC switch to INT to use the built-in
settings unless a user de
ned project template mono microphone or EXT to use microphones
is used.connected to the XLR inputs.
"EnableP HANTOM if microphones are
connected to the XLR inputs that require
Set Up Project Templatesphantom power.
1. Press the MENU key "Enable tLhEe FT and/or RIGHT -20dB PAD if
recording from a particularly loud source. This
2. Use the DATA wheel to scroll to Project Menuis only for the XLR inputs.
3. Press the SELECT key
4. Use the DATA wheel to scroll to Save as "Enable LOW CUT if there is undesirable low
Project Templatefrequency energy present such as traffic or air
conditioning rumble. This introduces an analog
5. Press the SELECT key
6. Name your project template and Savefilter at 100Hz.
"Enable LIMTER to protect against unexpected
NOTEtransients from overloading the D/A converters.
" This will save the system settings (excluding The STEREO LINK switch, when enabled,
recorded audio and markers) of the currently causes the limiter to engage on both channels
loaded project as a project template.when only one channel receives loud input.
Otherwise loud input on one channel will not
" A list of currently available project templates trigger the limiter on the other channel.
is available under the System Menu where
they can be renamed or deleted.
Menus
The Left/Right input source can be selected between
Analog and S/PDIF. This setting cannot be made
independently for the Left & Right channels. There
are two places where this setting can be selected:
1 .Within the current llyoade dproject?s
Settings menu:
2