61833030GB.fm Page 3 Monday, January 31, 2005 12:07 PM
SAFEGUARDING THE ENVIRONMENTDeclaration of conformity
1. PackagingThis product has been designed, manufactured and sold in
Packaging materials are 100% recyclable and are marked compliance with the following standards:
with the recycling symbol . Dispose of packaging materials - safety objectives of the ?Low Voltage? Directive
in compliance with local waste disposal regulations. Packaging 73/23/EEC
materials can be dangerous for children. Keep packaging
- protection requirements of ?EMC? Directive
materials (plastic bags, polystyrene, etc.) well out of their
89/336/EEC amended by Directive 93/68/EEC.
reach.
2. ApplianceTrouble-shooting guide
The appliance is made using recyclable materials.Hood does not work:
Dispose of it in accordance with local waste disposal ? Is the power plug properly inserted in the mains socket?
regulations. Cut off the mains lead to render the appliance ? Is there a power failure?
unusable before disposing of it. The appliance must be ? Is the mains fuse OK?
delivered to an authorized collection centre for scrapping.The hood is not extracting efficiently:
? Is the right extraction speed selected?
? Do the filters need to be cleaned or replaced?
? Are the air outlets blocked?
Light does not work:
? Does the bulb need to be replaced?
? Is the bulb correctly fitted?
PRECAUTIONS AND GENERAL
? Is the mains fuse OK?
RECOMMENDATIONS
WARNING!AFTER-SALES SERVICE
? Do not allow children or infirm persons to operate Before calling Technical Assistance
the appliance without supervision.1. Check to see if you can fix the problem yourself
? Make sure that children do not play with the (see ?Trouble-shooting guide?).
appliance.2. Switch off the hood for a few minutes and re-start it to
1. Do not connect the appliance to the mains electricity see if the problem has cleared itself.
supply until installation is completed. Always disconnect 3. If the problem persists, call Technical Assistance.
the hood from the mains before performing any cleaning Specify:
or maintenance.? The nature of the problem,
2. Do not flambé food under the hood. The flames ? the model of hood, stated on the data plate inside the
generated could cause a fire.hood, accessible by removing the grease filters.
3. Do not leave pans unattended when frying. Cooking oil ? your full address,
can catch fire.? your telephone number and area code,
4. Regular cleaning and maintenance is essential to correct ? the service code (the number appearing below the word
functioning and good performance. Regularly remove dirt SERVICE on the data plate inside the hood behind the
deposits. Regularly clean or replace filters. Never use grease filter).
flammable materials to convey exhaust air.If any repairs are needed, contact an authorized Service
5. If the hood is used together with non-electrically powered Centre (to ensure that only original spare parts are used and
that repairs are made correctly).
appliances, ambient negative pressure must not exceed
-5Failure to comply with these instructions may compromise
4Pa (4 x 10 bars). Make sure that the room is
the safety and quality of the product.
adequately ventilated.
Electrical connections
Before connecting the hood to the mains, make sure that the
voltage specified on the data plate corresponds to the voltage
in your home. The data plate is located inside the hood
behind the grease filter.
If the appliance is fitted with a power supply cable and plug,
the plug must be inserted in an accessible socket.
If the hood does not come pre-fitted with a mains plug, fit
one that conforms to applicable standards or use a double-
pole switch with a minimum breaking gap of 3 mm.
Replacement of the power supply cable with power plug or
flexible cable may only be carried out by an authorized
Service Centre or a qualified electrician.
5019 618 33030
D GBFNLEPIGR SN DK FIN |
ACEC
