Troubleshooting Guide
Tips and advice Before starting a wash programme, Crockery still dirty after washing:
make sure that the spray arms can turn
Arrange crockery so that items do not Was the crockery loaded properly?AFTER-SALES
touch each other. Arrange large freely and are not impeded by crockery Crockery, and in particular large items,
or cutlery.
crockery in the lower rack and smaller must be loaded facing downwards.SERVICE
crockery in the upper rack. Only switch off the dishwasher once
the? Start? indicator lamp has switched The water jets must spray the entIifr aftee r carrying out the above checks
Load cups at an angle to facilitate surface of all items.the malfunction persists or appears
off.
water drainage.again, turn the appliance off and turn
If the dishwasher is switched off du Make sure thatring crockery and cutlery are
Generally speaking, place cutlery ina wash cycl the e, when switched on again arranged properly.off the water supply tap, then call
our After-Sales Service (see guarantee).
basket with the handles positioned it will resume the cycle from where it
Have you selected the correct programme? Please specify:
downwards, but ensure that any sharwap s interrupted without having to start
Did you use too much or too little detergent? The nature of the fault.
knives and forks that might cause it again.
(The use of poor quality detergents may
injury are placed in the basket with the The appliance type and model.
result in less effective washing).
handles positioned upwards. The service code (the number after
Are the filters clogged or incorrectly the word Service on the adhesive
Make sure the water jet can reach aIf a ll fault occurs, before contacting our
rating plate) inside the door on
loaded items and that the spray armsAfter-Sales Service, make the following assembled? (See ?Care and Maintena?nce
chapter in the user instructions).the right-hand side.
turn freely.checks to try and remedy the problem:
The dishwasher is not working: Are the spray arms blocked or the nozzles
Important Is the plug properly inserted in the wall
clogged? (See ?Care and Maintena?nce
Fill the detergent dispenser and chsocketeck ?chapter in the user instructions).
the salt and rinse aid level. Is there a power failure?
Is the lower spray arm correctly fitted?
Is the dishwasher switched on?Your full address and telephone
Do not use the appliance for items not
Has the Start button been pressed?Is the salt container cap (water sonuftembenirng.
suitable for washing in a dishwasher,
Has the delayed start timer been set (if system) screwed down?
for example: wooden items, aluminium,
fitted)?Marked crockery:
plastic utensils, tin, hand-decorated
Is the water supply tap on?
crockery (unglazed), silver cutlery. Is the water hardness level selector not
Is the flow of water obstructed by
properly adjusted? ?Fil(Seline g the salt
Do not put liquid fat in the dishwasheimpurrit ies? If so, close the water supply
containe? ir n the user instructions).
(e.g. oil used for frying) or candleta wp,a dex.tach the water hose and clean the
If a fault occurs or you wish to chanfgeilt there . Then re-connect the water hos Is the e to salt container empty? (See ?Filling the
salt contai? inern the user instructions).
current programme, press th?STARTe ? the tap and open the water tap once
button for about 5 seconds until the Stagaiartn. Was insufficient detergent used? (See
indicator lamp switches off. Are the filters clogge?Cad? (Sre aneed ?Filling the detergent di? inspe thnsee r
Maintenance? chapter in the user user instructions).
If regeneration salt is to be added,
instructions).
immediately start a wash programme Marked glasses and cutlery:
Is the door closed properly?
in order to eliminate any residual salt Was too much rinse aid used?
Is a fault indicated?
(rinsing alone is not sufficient).(See ?Filling the rinse aid ?di inspe thne ser
(The Start indicator lamp flashes).
Sometimes even though the Start the programme again from the user instructions).
regeneration salt container has beeben ginning: press the Start buttonNo fte:or with some models, when the Start
filled, the corresponding indicator laaboump t 5 seconds, until the Start button is pressed a pre-wasindicator h cycle precedes
(if fitted) will light up during thelamp first switches off.the actual wash programme; this
wash cycle after filling with salt.Select a new programme and press tregenerateshe the water softening system.
Start button.
Please read the user instructions carefully. |
ACEC
