TEST MODE-5/6
Clearing the error display code3. When the O2� key is pressed, the total error counter is
displayed on LCD. Each time the O§� key is pressed, the
When all of the repair works are completed, clear the error display
display advances to the next display s shown below. Each time
code by the following procedure.
the O � key is pressed, the display returns to the previous
display. When the OREC� key is pressed, the error count
Y How to clear the error display code
during recording is displayed.
1. Enter the test mode. (Refer to TEST MODE on page 26.)
When the OREC� key is pressed, the total error counter is
2. Press the OJOG lever (left) L�(top) key or the ODISPLAY� key
displayed on LCD. Each time the O§� key is pressed, the
of remote control to enter the Self-Diagnosis Result Displaydisplay advances to the next display as shown below.
Mode.
When the O � key is pressed, the display returns to the
3. While the error code (any error code other than OR_****�)
previous display. When the O2� key is pressed, the error count
remains displayed on screen, press the O;� key twice.
during playback is displayed.
(All data of 1, N, N1 and N2 are cleared.)
Playback Sound Skip Record Sound Skip
Check Result DisplayCheck Result Display
Sound Skip Check Result Display Mode
The error counts of the errors that have occurred during recording and
playback of this machine can be displayed to check them.
Y How to Enter the Sound Skip Check Result Display Mode
1. Enter the test mode. (Refer to TEST MODE on page 26.)
2. Press the O2� or the OREC� key. Then the machine enters the
Sound Skip Check Result Display Mode of either during
recording or during playback. The following display appears
on LCD screen.
Display on remote control LCD.
Total error count of the
: Playback/record error total count (hexadecimal)
record system (hexadecimal)
: Sound skip check item counter (hexadecimal)
Total error count of the
playback system (hexadecimal): The address that causes the sound skip
at the latest. 6-digit address (hexadecimal)
Y Cause of sound skip error
Cause of
Description of the error
the error
EIBSound error correction error
StatDecoder status error
Playback
AdrsCannot reach the target address.
BEmpBuffer became empty.
BOvrBuffer became full and sound skipping occurs.
Amount of remaining buffer became scarce
Bful
Recordingand forced write occurs.
Having exceeded the maximum number of
Rtry
retries
4. To exit the Sound Skip Check Result Display Mode and to
return to the test mode (display check mode), press the O9�
key.
-30- |
ACEC
