DISASSEMBLY INSTRUCTIONS
1. Removing the PANEL, BOT
Remove the screw A*1 and screw B*6, and remove the PANEL, BOT in the direction of the arrow.
*When attaching the PANEL, BOT, set the KNOB, SL HOLD.
KNOB, SL HOLD
B
PANEL, BOT
BA
B
BB
B
2. Removing the MAIN C.B
1) Connect the shorting lands of the pickup by a solder bridge.
*When the MAIN C.B is attached, remove the solder bridge.
2) Remove the FFC of the CN300, CN700 and CN100.
3) Remove the screw A*3 and screw B*1.
4) Remove the battery lid and remove the MAIN C.B, while being careful of the BAT-CONTACT +.
*When the MAIN C.B is attached, be careful of the BAT-CONTACT +.
HINGE ASSY, BATT
* The BAT-CONTACT + is attached under
the HINGE ASSY, BATT
B
A
BAT-CONTACT +
A
A
MAIN C.B
4 |
ACEC
