IC DESCRIPTION -1/1 (IC, LC78602HNE-8612D) -2/2
Pin No.PinI/OFunction
Random mode indieator output.
46RANDOMO(Low : random mode , high , modes other than random mode).
Synchronizing signal detection output. Outputs a high level if the synchronizing
47FSEQOsignal detected from the EFM signal and internally generated synchronizing signal
match.
48DMUTEODriver mute control signal output. (Low : driver mute , High : driver not mute).
49VDD5VÅ Digital power supply for pins.
C2 error signal monitor.
50C2FO(Note that this output pin is only provided for testing. Mount a external resistor
between VDD5V in order to monitor this signal but connect this pin to the digital
ground in normal mode operation.)
51AMUTEOAudio mute control signal output. (Low : audio mute , High : audio not mute)
52REMOTEIRemote controller signal input.
53RMTSL2IRemote controller identifier input (2). A pull-down resistor is built in.
(Open : "0" . Connected to VDD5V : "1")
54LCHOOleft channed D/A converter output.
55L/RVDDÅ D/A converter power supply.
56L/RVSSÅ D/A converter ground. This pin must be connected to 0V.
57RCHOźRight channel D/A converter output.
58CLOSE?Close switch detection input. A pull-up resistor is built in.
59RMTSL1?Remote controller identifier input (1). A pull-up resistor is built in.
(Connected to digital ground : "0" . Open : "1")
60XOUTźConnections for a 16.9344MHz crystal oscillator element.
61XIN?
62XVDDÅ Crystal oscillator circuit power supply.
63RESILSI reset input. Applications must be set this pin low temporarily when power is first applied.
64DRFIDRF input.
-30- |