SPEAKER DISASSEMBLY INSTRUCTIONS
Type.1Type.4
Insert a flat-bladed screwdriver into the position indicated by theTOOLS
arrows and remove the panel. Remove the screws of each speaker
1 Plastic head hammer
unit and then remove the speaker units.
2 (() flat head screwdriver
3 Cut chisel
123
How to Remove the PANEL, FR
Type.2
1. Insert the (() flat head screwdriver tip into the gap
Remove the grill frame and four pieces of rubber caps by pullingbetween the PANEL, FR and the PANEL, SPKR. Tap the
out with a flat-bladed screwdriver. Remove the screws from holehead of the (() flat head screwdriver with the plastic
where installed rubber caps. Insert a flat-bladed screwdriver intohammer head, and create the clearance as shown in Fig-1.
the position indicated by the arrows and remove the panel. Re-
move the screws of each speaker unit and then remove the speaker2. Insert the cut chisel in the clearance, and tap the head of
units.the cut chisel with plastic hammer as shown in Fig-2, to
remove the PANEL, FR.
3. Place the speaker horizontally. Tap head of the cut chisel
with plastic hammer as shown in Fig-3, and remove the
PANEL, FR completely.
Type.3
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Turn the speaker unit to counter-
clockwise direction while inserting a flat-bladed screwdriver into
one of the hollows around speaker unit, and then remove the speaker
unit. After replacing the speaker unit, install it turning to clockwise
Fig-1Fig-2
direction until "click" sound comes out.
Fig-3
How to Attach the PANEL, FR
Attach the PANEL, FR to the PANEL, SPKR. Tap the four
corners of the PANEL, FR with the plastic hammer to fit the
PANEL, FR into the PANEL, SPKR completely.
� 47 � |
ACEC
